Electronics Forum | Tue Jul 25 08:34:30 EDT 2006 | GS
Does your board passes also through the wave solder step ? If, yes, it could be a matter of secondary reflow on BGA ball solder joints. Best Regards....GS
Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Mon Aug 25 10:36:05 EDT 2008 | davef
Yes, it's peculiar that the layout of this board is so disorganized * Pads are not round, uniform, or the same size * Exposed traces have different thickness
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
Electronics Forum | Thu Jan 14 08:32:22 EST 1999 | Jim Nunns
They are supposed to be production parts. Our volumes are in the hundreds due to rapid change though. Jim Nunns | Just a comment: we've seen PBGAs curl up at the corners, but only on prototype components that came off of a low-volume "prototype"
Electronics Forum | Thu Jan 21 15:24:18 EST 1999 | Terry Burnette
| I have received prototype PBGA (256 pins) devices from | Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I h
Electronics Forum | Fri Jul 21 12:15:52 EDT 2006 | CKH
Hi Folk, every now and then, i would encounter Functional Failure due to BGA ICs. The Testing Tech always conclude that the contact of the BGA to the PCB Pad is poor. The 2D/3D X-ray machine can't detect any of the poor contact on the BGA..... We
Electronics Forum | Mon Jul 24 13:45:14 EDT 2006 | samir
Most Test Technicians, Managers, and everyone else in the organization always believe that the BGA is the #1, and most likely failure mode in a circuit. You can analyze it with all the tools available...2D, 3D, 10D, underneath, etc...... convince th
Electronics Forum | Thu Oct 28 13:36:14 EDT 1999 | Bart Smith
I am a design engineer and have a circuit board design with a 292 pin BGA on it. The board manufacturer is experiencing a failure rate of about 2.8% on the BGA device due to soldering problems. This is my first experience with BGA. How does the 2.
Electronics Forum | Fri Aug 16 09:59:49 EDT 2002 | dason_c
We baked the board first and print 2 mil water soluble paste at the BGA location and reflow. Wash and baked before the production run.
