Electronics Forum | Thu May 13 21:45:14 EDT 1999 | ardis
I am seeing reflow around my signal pins after being subjected to a profile of 204c for 1 minute and 225c for a min of 30 seconds. Signal pins are soldered into a copper plated alum. case with SB5 and then silver plated. The pins have a hot oil tin
Electronics Forum | Fri May 14 00:28:09 EDT 1999 | Mike D.
| I am seeing reflow around my signal pins after being subjected | to a profile of 204c for 1 minute and 225c for a min of 30 seconds. Signal pins are soldered into a copper plated alum. case with SB5 and then silver plated. The pins have a hot oil
Electronics Forum | Tue Sep 10 08:22:36 EDT 2002 | davef
I doubt that the interposer is FR4, it's more likely to be BT. Warp during reflow is a function of material a reflow recipe. Your ramp is too fast and is causing the interposer to bend like a potato chip.
Electronics Forum | Tue Sep 07 22:15:26 EDT 1999 | NAZEEH CHAUDRY
| | | I have a zevatech 570 and 560 my boss want to place bga.s with these machines, Ive told him he needs to ugrade to newer machines. Zevatech say "no problem our machine are number 1". | | | these machines dont even offer bga selections. These mac
Electronics Forum | Tue Sep 07 06:14:27 EDT 1999 | Earl Moon
| | I have a zevatech 570 and 560 my boss want to place bga.s with these machines, Ive told him he needs to ugrade to newer machines. Zevatech say "no problem our machine are number 1". | | these machines dont even offer bga selections. These machine
Electronics Forum | Tue Sep 07 22:07:56 EDT 1999 | NAZEEH CHAUDRY
| | | I have a zevatech 570 and 560 my boss want to place bga.s with these machines, Ive told him he needs to ugrade to newer machines. Zevatech say "no problem our machine are number 1". | | | these machines dont even offer bga selections. These mac
Electronics Forum | Wed Sep 11 23:20:44 EDT 2002 | scottefiske
Profiles are absolutely the first course of action to validate. A few additional questions would be: * Moisture can cause warping as well, verify the manufacturers recommended handling procedures were followed. * Where is the suspect BGA located
Electronics Forum | Wed Apr 28 22:35:32 EDT 2004 | davef
We can clean the blank out of LARGE BGA. [Cleaning small BGA is a whoooole nuther issue.] But before we get into that, what's the problem and its breadth? Why are you getting poor wetting? What's the story on the components, board, process materia
Electronics Forum | Tue Apr 27 08:14:59 EDT 2004 | iqbal
Is anybody doing BGA soldering water clean solder. If yes how you are ensure cleaness. We have boards with Four BGA and 2000 chip and ICs.We are processing with no clean solder but we are getting bad wetting so now we are planning to switch to water
Electronics Forum | Tue Mar 09 17:41:24 EST 2004 | davef
Try this: * Run the board through your reflow oven set for a "normal" recipe, but with the cooling section turned off. * Pick the BGA from the board while the solder is still liquid using tweezers [or similar tool].
.gif)