Electronics Forum | Thu Jun 19 21:39:31 EDT 2008 | mika
Hi, we used to have a RoHS package with uBGA 380 Solder ball's 0.8 mm pitch approx 15x15 mm, bump size is 0.4mm on a 0.33mm pad. Suddenly we need to use another vendor for various reasons. However, the new bump size is 0.45mm according to specs and t
Electronics Forum | Tue Feb 26 08:02:30 EST 2002 | cyber_wolf
I know that there is an IPC spec. for board pad size design for BGA components. After a little research we have found that recommendations vary from component manufacturers to board houses. (These recommendations are different than what IPC says....)
Electronics Forum | Tue Feb 26 07:55:23 EST 2002 | cyber_wolf
I know that there is an IPC spec. for board pad size design for BGA components. After a little research we have found that recommendations vary from component manufacturers to board houses. (These recommendations are different than what IPC says....
Electronics Forum | Tue Feb 26 10:42:48 EST 2002 | davef
Consider the hierarchy presented in http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=18112
Electronics Forum | Wed Aug 27 08:25:24 EDT 2008 | davef
We'd expect to see: * Solder starved connections at pads with large trace/pad areas. * Less reliable solder connections at pads that do not match the shape and size of the corresponding pads on the component.
Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads
Electronics Forum | Mon Aug 25 10:36:05 EDT 2008 | davef
Yes, it's peculiar that the layout of this board is so disorganized * Pads are not round, uniform, or the same size * Exposed traces have different thickness
Electronics Forum | Fri Aug 22 03:19:08 EDT 2008 | andrzej
Hi, what do you mean by collapsed ? Can you describe or send a photo ?
Electronics Forum | Mon Aug 25 08:44:10 EDT 2008 | rameshr
Dear Andrezj, i had attached the photos for ur reference Kindly advice.
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
