Electronics Forum: bga x5 (Page 1 of 1)

Shielding from Nearby Heat-Any Tricks

Electronics Forum | Wed Dec 24 11:49:46 EST 2008 | bandjwet

Put on your thinking caps for this one......We are trying to remove a BGA (10 x 10mm, plastic, 0.8mm pitch) which is approx 3 mm next to another BGA (5 x 5mm, plastic, 0.8mm pitch). The challenge is this second device is underfilled with a softening

Very Low Volume BGA Assembly

Electronics Forum | Tue May 23 17:49:07 EDT 2006 | flipit

Hi, Ok I have some numbers for you on my process. For the last 2 years we have been placing 4 BGA on a 2" X 5" X 0.062" PCB. The BGAs are 16X16 256 ball, 15X11 165 ball, 8X8 64 ball, and 26X26 456 ball. The 8X8 is 0.8mm pitch and the others are 1

BGA underfilling

Electronics Forum | Thu Nov 15 13:46:28 EST 2001 | Terry Burnette

Underfilling PBGA's will increase the PCB level solder joint life by 4x-5x but we only recommend underfill for products going into extreme environments. Normally the 272ld and 388ld PBGA's solder joints when cycled at -40C to +125C should not see any

Lead free parts on a leaded assembly

Electronics Forum | Thu Oct 05 15:58:16 EDT 2006 | RusH

Mario, Thanks for your response. We are building a leaded assembly with hot air leveled Sn/Pb pads on the PCB. In one case the component is a 7.5X5.2X1.8 wire wound ferrite inductor with Au/Sn leads. The second component is an 0808 Tantalum cap,

type 3 vs type 4 paste

Electronics Forum | Fri Nov 08 14:48:58 EST 2002 | davef

Yours is (12 thou x12 thou)/(2x(12 thou +12 thou)x5 thou) = 0.60 * Aspect=W/T for electroformed stencils SB GT 1.1 => Yours is 12 thou/5 thou = 2.40 So, we kind of think of what you�re trying do as maybe printing a 16 pitch QFP, which gives you simi

  1  

bga x5 searches for Companies, Equipment, Machines, Suppliers & Information

2024 Eptac IPC Certification Training Schedule

High Throughput Reflow Oven
Circuit Board, PCB Assembly & electronics manufacturing service provider

World's Best Reflow Oven Customizable for Unique Applications
SMT feeders

Have you found a solution to REDUCE DISPENSE REWORK? Your answer is here.