Electronics Forum | Thu Jul 08 12:33:52 EDT 1999 | Mike Demos
Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. I wi
Electronics Forum | Thu Jul 08 15:38:27 EDT 1999 | Earl Moon
| Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. |
Electronics Forum | Sat Mar 21 09:09:40 EDT 2009 | davef
Your puzzlement about blowholes in PTH solder connections during reflow soldering comes from: * Boards are hydroscopic. So, moisture content of the board is uniform. * Gold plating is uniform. * Nickle plating is uniform. * Copper plating on your PTH
Electronics Forum | Tue Jul 28 14:34:47 EDT 1998 | upinder singh
Hello everybody. Remember I posted some questions on the smtnet regarding placing the thru hole connector using paste and reflow(pin in hole). I have able to accomplish the process succcesfully.....but I have a problem. The boards are failing at the
Electronics Forum | Thu Oct 05 10:37:10 EDT 2006 | David
Hello all, We have problem with voids in one of our product. We are soldering IC (package SO8) with under the components grounding connection. The ground pad for this component has 3 via holes (before producing we have to cover this 3 holes from b
Electronics Forum | Wed Jul 29 17:39:40 EDT 1998 | David Spilker
| Hello everybody. | Remember I posted some questions on the smtnet regarding placing the thru hole connector using paste and reflow(pin in hole). I have able to accomplish the process succcesfully.....but I have a problem. The boards are failing at
Electronics Forum | Tue Jul 28 16:13:45 EDT 1998 | Steve Gregory
| Hello everybody. | Remember I posted some questions on the smtnet regarding placing the thru hole connector using paste and reflow(pin in hole). I have able to accomplish the process succcesfully.....but I have a problem. The boards are failing at
Electronics Forum | Thu Feb 13 03:54:57 EST 2020 | majdi4
we are obliged by customer specifications that there will be no glue despensing process on the production line.. also that the glue dispensing process is very complicated for this case .. we could have glue splash on top surface of pcb so that will
Electronics Forum | Fri Jun 07 05:19:23 EDT 2019 | gregoryyork
dont usually see this unless the Rosin hasnt been hardened due to low reflow or excessive pressure on blades squeezing flux out so you have flux rich areas. Are these boards also flow soldered?
Electronics Forum | Wed Apr 21 14:29:58 EDT 1999 | joe devaney
| Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The proces