Electronics Forum | Mon Jun 26 08:54:35 EDT 2006 | dougs
We have a new product in where a 0.7mm pitch uBGA is to be placed on a 2 layer flexi board. Also a 20thou pitch connector. Has anyone done anything like this before, what should i look out for. Not done much flexi work before so any tips will be g
Electronics Forum | Sat Jul 29 09:10:16 EDT 2006 | davef
Ball Grid Array (BGA). A surface mount technology leadless package with the connectors to the board placed in an array on the bottom of the package. They are attached to the board with tiny balls of solder placed on each contact. Pin Grid Array (P
Electronics Forum | Tue May 22 16:07:31 EDT 2007 | francitj
We are doing a field study to test the placement accuracy and calculate cpk of some machines in our plant. From previous readings, it is suggested that you buy glass board kits from Accuspec, Topline, etc. Is that the easiest/cheapest way to go abo
Electronics Forum | Thu Aug 23 16:28:14 EDT 2007 | grics
I want to get a collective opinion from the forum... I was always under the impression that Humidity at SMT can be a disaster and can cause solder balls... But what about at the Wave/Selective solder? If every board or almost every board has solder
Electronics Forum | Wed May 20 17:00:56 EDT 2009 | dyoungquist
We just placed a 56 pin QFN, 1 per board, on 10 boards and had zero defects. A good paste job, proper placement and a correct oven profile are the keys. If these are set up correctly, on larger runs your defects won't be zero but they should be le
Electronics Forum | Thu Mar 31 15:53:23 EDT 2022 | stephendo
And pin outs of both. Once I saw a SOT-6 replaced with a miniSOT-6 (IIRC) The pin outs of the two parts were different. We did make an adaptor board and it wasn't too bad. We populated a panel of the adaptor boards, depanelized them and put them in t
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Fri Jul 23 10:47:31 EDT 1999 | Mark D. Milward
There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing th
