Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Tue Jan 09 08:26:51 EST 2007 | stepheniii
If your boards are not totally rectangular part of the board can stick out past the stopper. If the fiducial is there then you can't use it. Also make sure you are not using panel fiducial co-ordinates and then expanding those out with panelization
Electronics Forum | Thu Jan 26 08:44:22 EST 2017 | muzzy
Hi. Thanks for the reply. If i remember correctly, there aren't any crosshairs displayed when the machine stops. Last time I used it, I tried jogging it to another position after the error but couldn't do it. I'll try it again when i will get a chanc
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
Electronics Forum | Sun Nov 06 03:09:44 EST 2016 | muzzy
Hello. Thank you for your answer. Yes, you are right. It would be best to badmark those boards. But we, as a small contract assembler, can't throw away a 1/5 of client boards just because of damaged fiducials. Using pads and other features as fiducia
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
.gif)
winsouce.jpg)