Electronics Forum | Wed Feb 12 17:10:02 EST 2003 | Mike G
Most conveyors are sold by the inch. I allow for no more than one inch gap between the end of the conveyor and the next piece of equipment. If you trust your measurements, 1/2 inch is best. This will allow for the smoothest transfer possible of small
Electronics Forum | Wed Feb 12 18:41:39 EST 2003 | russ
I'm with Mike G, We use a 1/4"(1/8" gap on both ends)! We process very short boards from time to time and any more space causes transfer errors. Also, the very short gap helps alot when lining them up. Russ
Electronics Forum | Wed Nov 01 11:08:13 EST 2000 | CAL
the same differences that seperate Cadillac and BMW's in the auto world. Lines, look, performance, convienence, sound. A conveyor with wires, hoses, loud solenoids, are undesireable. Stien Automation/ Cyclone Automation Have a Newly released conveyor
Electronics Forum | Fri Aug 06 05:04:45 EDT 2021 | oxygensmd
Hello Everyone, I am looking for manual for the following equipments: Asys MPS 50D (mag buffer), Asys TDM 03 (telescoping conveyor), Asys AES01 (1mag loader), Asys LSB 03 (stacker). I hope you can help.
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Sat Jan 22 16:39:26 EST 2011 | eadthem
Your typical high mix line would consist of, Stencil printer, 1-2 foot conveyor belt, fast PNP machine (say a universal 30 spindle turret lightning head), 1-2 foot conveyor belt, large/heavy part PNP (say a universal flex jet 7 spindle or 4 Spindle),
Electronics Forum | Mon Jan 17 10:06:26 EST 2011 | rgduval
Leo, Everyones goal is to minimize the manual handling of assemblies in process. To that end, conveyorizing your entire line, from board onload, through reflow, and potentially inspection is the ideal. However, that isn't always possible. There a
Electronics Forum | Mon Aug 27 15:50:05 EDT 2001 | seand
Hello Everyone, The MPM UP 3000 may be a good bet for your Screenprinting application and I am aware that there are a few in inventory at Speedline Technologies (MPM) that you should be able to get with a warranty for a good price. I know wide vers
Electronics Forum | Tue Dec 11 12:44:34 EST 2012 | deanm
We recently acquired another machine and am faced with the same issue. We are a low volume/high mix company. I chose to run them in series so I can put the more common parts on the first machine and leave them there and put the parts that change from
winsouce.jpg)