Electronics Forum | Fri Dec 09 01:05:11 EST 2022 | varun
We have a Mirtec MV-3U AOI machine. Can someone help me to find a way on how to save the image of the board along with the report after the inspection is complete? Currently it only saves the report with the errors showing on the template image which
Electronics Forum | Tue Oct 03 18:13:46 EDT 2023 | glasscake
Its ether going to be in the settings before launching the software at the login screen or the settings after launching the softer on the top right. You should see some tab relating to defects. There should be a setting that says something along the
Electronics Forum | Wed Apr 30 09:13:30 EDT 2003 | pjc
Yes, there is a limitation with Transmission X-ray on double-side SMT boards, ie.: back-to-back solder joints, components on bttom side over a solder joint.
Electronics Forum | Tue Nov 30 11:08:22 EST 2004 | jdumont
Hey all, we will be starting to coat our PCB's soon. I am looking for info on what type of UV light is needed to inspect the boards. We will be using Humiseal 1B73 Acrylic coating. TIA, JD
Electronics Forum | Wed Dec 14 06:18:20 EST 2005 | tk380514
right again grant, consider the fact that if you spend enough time inspecting the soldered boards/pre-oven and check the BGA solder paste pads before, and clean the stencil regularly and check solder paste dryness, check oven profiles then after chec
Electronics Forum | Thu Oct 29 21:16:15 EDT 2009 | mah115
Fellows, We are considering getting an AOI machine to inspect boards that our vendors are giving us (we outsource the assembly of PCBAs). We have low volumes of boards, but every time a defect does slip by our human inspectors, it causes a lot of
Electronics Forum | Wed Mar 14 17:11:57 EST 2001 | davef
First, x-ray inspection machines have a wide range of capilities. Resolution is a key measure of a machine's ability to "distinguish" features. People say that some x-ray inspection machines have the ability to position the board being inspected at
Electronics Forum | Tue Aug 03 09:38:39 EDT 2004 | Danny
We are a small PCBA contract manufacturer based in Malaysia. Sometimes, our customers request us to provide X-ray inspection on BGAs. Due to our production mode is towards high-mix low-volume, it is a bit difficult justifying purchase of X-ray inspec
Electronics Forum | Fri Jan 11 02:07:08 EST 2002 | ianchan
For repeated model runs, we go ahead with the SMT run, whilst the QA does the FA inspection. Limit FA timing to 2h or less...(simple boards yield faster time cycles). For new model runs, yep, we wait for QA to confirm the FA inspection, only with QA
Electronics Forum | Tue Apr 06 14:45:52 EDT 2010 | stepheniii
You would be suprised what you can see with even a simple Xray machine. The engineers upstairs wanted to see if the xray could confirm there was an open via on a thin dense board with several layers. I thought (but didn't say) no way. But with carefu
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
