Electronics Forum | Wed Aug 18 10:28:17 EDT 1999 | Carol Zhang
Hi, I'd like to ask some tips about the merits and shortcomings o of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our application? The boards contain no BGA and the fines
Electronics Forum | Wed Aug 18 15:20:25 EDT 1999 | John Thorup
| Hi, | I'd like to ask some tips about the merits and shortcomings o | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | application? | The boards contain no BGA and
Electronics Forum | Wed Aug 18 17:59:09 EDT 1999 | Mik Horvath
| | Hi, | | I'd like to ask some tips about the merits and shortcomings o | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | application? | | The boards contain
Electronics Forum | Wed Aug 18 18:10:33 EDT 1999 | Mik Horvath
| | Hi, | | I'd like to ask some tips about the merits and shortcomings o | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | application? | | The boards contain
Electronics Forum | Wed Aug 18 21:10:23 EDT 1999 | se
| | | Hi, | | | I'd like to ask some tips about the merits and shortcomings o | | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | | application? | | | The board
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Wed Apr 26 18:35:07 EDT 2023 | poly
I'm looking to make a board support table fixture that is connected to the printer and uses the vacuum manifold of the printer. Printer is an mpm Accela
Electronics Forum | Thu Apr 29 13:27:36 EDT 2004 | Kirk
Is it possible to put PCB to the screen printer with vision and on the board put sheet of paper then make print on the paper and it is the reference then i teach vision for example fine pitch aperture then remove paper and align PCB? We have semi-a
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
.gif)
winsouce.jpg)