Electronics Forum | Thu May 09 17:16:16 EDT 2002 | davef
Russ makes a good point. While your profile probably meets your paste supplier recommendations, it may not be proper for the component. * Paste suppliers offer general recommendations for tin / lead interconnects. You need to modify that for board
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Wed Aug 21 09:09:50 EDT 2013 | wcheew
I am having solder barrel fill issues on THM component, we follow, we follow IPC 610 E requirement. The barrel fill issues happen on signal & ground pin at connector & E-cap. I found out that most of the insufficient solder happen on the connector ag
Electronics Forum | Wed Mar 01 07:48:33 EST 2017 | coryhayes89
I have an older Flexlink F1700 that I am having issues with and am hoping someone might have a fix for it. The issue is that the machine will initialize when you turn it on, meaning the belts will spin. However, it never returns to its 'home' posit
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Tue Sep 01 01:05:24 EDT 2015 | rgarcia0626
I'm not familiar with you machine but it seems the problem is not the motor. if there's a manual I/O, switch on your conveyor from there and check if there's a voltage going into the motor.Check the control boards for the conveyor, relays and sensors
Electronics Forum | Tue Aug 09 14:41:32 EDT 2005 | jdengler
I do not know JOT conveyors but I do know other manufacturers. Based on that I do not believe this alone will work: -fixed rail on wrong side probably -sensors for board control in wrong location -smema ports may be to far from where they need to co
Electronics Forum | Sat Dec 08 22:44:59 EST 2018 | youngbuck
Hi, Was wondering if anybody has any experience with F5 with the conveyors will work sporadically. If I put a board on the input sensor in which it sees it will work, the next 5 minutes it won't work. Could this relate to the K2 relay, if so does any
Electronics Forum | Tue Aug 09 17:01:59 EDT 2005 | dougt
Is there a need for a professional conveyor swapper? Could I start my own business and make enough money doing something like this? I haven't worked on this conveyor but I'm sure I could figure it out. As it was said previous it's probably only a c
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
