Electronics Forum | Wed Sep 01 02:48:49 EDT 2021 | cmchoue
Hi Experts, I'm looking for how to auto skip the AXI(X-Ray) inspection on X-out board,Did any folks have the experience on this? Looking for your advice. AXI machine,Virtox and Matrix Thank you CM
Electronics Forum | Mon Oct 20 21:57:58 EDT 2008 | jdt13
The problem that I see is the pads not soldered and I can see on the X-Ray the solder on the pad after reflow, and yes the solder has melted in a uniform fashion, I have not measured the diference of temperatures in each pad of the PCB, the size is a
Electronics Forum | Mon Feb 16 14:18:30 EST 2009 | jorge_quijano
1000 0402's, Micro BGA, QFP 0.4mm pitch, TSOP), we are trying to know what kind of equipment do you recommend to use in our factory, we already have Screen Printer, Chip shooters, Reflow oven, AOI, Stencil cleaner (manual), X ray, ICT... what else do
Electronics Forum | Thu Jan 19 12:38:03 EST 2012 | cobham1
I am wondering if the failurs that people see are discovered right away or when the units are out in the field. Reason I ask this follow up question is the units that are having problems are all returns from our customers. Is there a way to check for
Electronics Forum | Tue Jun 20 08:30:31 EDT 2006 | dougs
It's hand solder, the wires are free issued, what i'm finding is that if we keep the heat and push enough solder into the joint that the component side wets there is that much solder moved up the wire that it goes solid. this is no good as the custo
Electronics Forum | Fri Jun 18 10:24:12 EDT 1999 | John Thorup
| first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. an
Electronics Forum | Mon Mar 02 00:38:35 EST 2009 | sachu_70
Hi Jorge, The success of such production purely depends on process control. One needs to first understand the board layout in detail, and evaluate any critical components for their temperature handling capabilities. Remember, you are dealing with com
Electronics Forum | Fri Jun 18 11:33:16 EDT 1999 | Brian wycoff
| | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads.
Electronics Forum | Tue Mar 09 22:13:20 EST 2004 | Ken
What x-ray system are you using? Check out Dage. I bet you have voids...just can't image them. Why the fuss over voids? Voids terminate the crack propegation and can extend the time to failure for creep fatigue. I would not be concerned unless yo
Electronics Forum | Sun Nov 10 09:58:38 EST 2013 | kumuda
We have been using a circuit board in the assembly of HV Tank used in X-ray generator. This board acts as a sealant to the oil tank opening. The top side area of the board which comes in contact with oil is conformal coated to avoid oil leak. However
.jpg)
