Electronics Forum | Fri Oct 07 14:37:36 EDT 2005 | jimmyjames
Could I get some help please? I have a Heller 1700EXL, 7 zone oven and I'm trying to figure out a better way of off-loading my completed boards. What I have now is simply a small table at the exit of the oven with about an 8" drop from the top of
Electronics Forum | Fri Oct 07 14:59:07 EDT 2005 | gregcr
Hi Jimmy, We use flat belt exit conveyors. They are set-up to collect the boards and set off an alarm when the belt is full. This allows the boards to come out, but you don't have to pay someone to stand there and catch each board. Also eliminate
Electronics Forum | Mon Oct 10 06:54:03 EDT 2005 | ajay
we do have staker whick can stak 30 boards automatically. As sson as it get segnal / sencor activeated one stak up & up to 30. after 30 it will give buzzer if boards are not remobed on time
Electronics Forum | Tue Oct 11 11:52:58 EDT 2005 | chunks
Elektrobit (JOT) makes a wave unloader you can use to put your board back onto an edge conveyor (if you are using just a belt on your oven now) and then place a FIFO or Mag Loader after that.
Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123
We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.
Electronics Forum | Fri Sep 14 08:53:43 EDT 2012 | mbnetto
Hi, Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave o
Electronics Forum | Mon Jun 10 08:51:01 EDT 2019 | don_julio
Thank you Clare. After doing some more research, I found they are known in the industry as "Carriers". I did look into that durostone material. They prices are beyond reasonable. My trek now is seeking a material to make planks out of to lay the b
Electronics Forum | Mon Jul 29 09:36:59 EDT 2002 | pjc
From the time the last board from "Job A" exits the oven until the first board from "Job B" exits the oven.
Electronics Forum | Wed Aug 30 11:10:24 EDT 2000 | Steve Thomas
you also may find that varying the width/spacing of your breakaways affects how they run through a pass-through system, if you utilize one. They can raise he!! with conveyor sensors, throw timing off, send printers into a new cycle before the board
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
