Electronics Forum | Fri Aug 03 09:21:08 EDT 2001 | Ian T
hi my company is planing to purchase an aoi system to be used inline. is there anyone out there doing this, if so do you use all the machine options (pattern character recognition, bad board marks, correct part polarity...) or do you dumb it down(pa
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Thu Mar 30 11:10:43 EST 2000 | Gary Kemp
Is the same marking protocol used when identifying 0603, 0402, etc.. components? For instance, would a 27.4K ohm 1% resistor still have four (4) characters to identify if the body color is black? Any feedback is appreciated. Thanks.
Electronics Forum | Tue Apr 01 09:46:26 EDT 2008 | patsama_n
Thank you for kindness advice. From the result of IC after pass the reflow process. The color of letter will change to similar color of material compound of IC. Then when we inspection by AOI machine, we have many problem about high fault reject rate
Electronics Forum | Fri Mar 28 01:45:10 EDT 2008 | En-Apple
I have problemabout fault reject rate at AOI very high, due to inspection letter or marking on IC body. It have uncleary. When I check at raw mat'l of IC it no problem but after pass reflow process it show marking not clear ( Laser marking type). Ple
Electronics Forum | Tue Mar 04 20:47:48 EST 2008 | davef
Available on the web, JEDEC PUBLICATION 95, DESIGN GUIDE 4.14, Ball Grid Array Package (BGA), Figure 4.14-3, Note 10: A1 corner must be identified by chamfer, ink, mark, metalized markings, indentation or other feature of package body, lid or integra
Electronics Forum | Wed Feb 28 15:11:45 EST 2024 | emeto
Hello all, I have a flux over components that affects AOI results in reading the symbols on top of it. What would you recommend to minimize this effect?
Electronics Forum | Mon Mar 31 09:16:41 EDT 2008 | davef
What is changing the marking on the part? * Is flux residue coating the part to change the the way light reflects from the part surface? [Run a board with tape on the part, then remove the tape prior to AOI] * Is the heat of the oven changing the mar
Electronics Forum | Wed Apr 02 09:56:59 EDT 2008 | patsama_n
Every time to create new AOI program we must manual set at bright lighting level for each component. then this case we think the parameter of AOI setting it not concern for this problem due to the golden board that we use to confirm machine before st
Electronics Forum | Wed Apr 02 15:35:27 EDT 2008 | jdengler
Our AOI machine can save various views of the same part number since we all know that different manufacturers will mark parts differently, some manufacturers vary their own marks. We get parts from the same manufacturer but different date codes that