Electronics Forum | Wed Apr 03 20:23:44 EDT 2024 | lremme
I tried to clone my cfi-128 flash memory card, but can't get it to boot. I am concerned because I have no backup if the original Flash card stops working. Does anybody have a flash card with Topaz-x VIOS and (MSDOS 6.2) preloaded? I would be looking
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Thu Feb 06 12:32:24 EST 2014 | gnus
Hi all, During our last production run, our MyData TP9 machine shut down on its own mid assembly. Screen went blank. I turned off the power switch and waited 10mins before trying to power it up again. I turn the switch on and hear the fan turning on
Electronics Forum | Thu Nov 12 10:27:12 EST 2015 | goodting
More info. The screen is now invisible. Any single tip to boot the machine?
Electronics Forum | Thu Nov 12 10:16:25 EST 2015 | goodting
Good day. I am asking if anyone knows how to access/have a copy of our BIOS file. This BIOS file which was designed by Phoenix , called biosrec.zip. Each day, we used the main EPC-1316(PCA,CPU/PMC)card to boot our Advantis machine; but the speciali
Electronics Forum | Tue Apr 02 19:21:57 EDT 2024 | lremme
I cloned the Flash Memory Card (CFI-128MDG ) for the Topaz-X (circa 1998). The contents looks identical to the orginal, but it will not boot the machine. Has anybody tried this and know what is wrong? (MSDOS 6.2 OS) thanks!
Electronics Forum | Mon Apr 08 00:06:58 EDT 2013 | toddmahon
Have you had any luck? I just purchased the same machine and it has some kind of a boot error. After power up a screen pops up in Japanese with English sub titles. In the bottom left corner it reads Memory Card Data Error - Load Data. I connected to
Electronics Forum | Thu Dec 24 14:37:58 EST 2020 | marcelorotofrance
Hi again Bob. I have checked the machine and it resulted that the files of that program were corrupted in some way. All other programs worked fine. I have a back up copy of all progs in a different drive so I fixed it. Two days ago there was a huge b
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
1 |