Electronics Forum | Fri Jun 30 08:16:28 EDT 2023 | gfe
Hello Bob, yes it was the Y1 that broke down, it was replaced by another machine, thank you.
Electronics Forum | Sun Feb 15 16:57:11 EST 2009 | p4qmtto
Hi. We had a similar trouble in a same oven's model. In each one of the heat zones, you have a thermal sensor to avoid an over heat. All of them are conected in a serial circuit with the coil of the main contactor for the preheaters power. If anyone
Electronics Forum | Fri Sep 02 10:27:49 EDT 2005 | Rob
One of our customers picked up an assembly, dropped it on a concrete floor, then kicked it down the corridor. Broke his toe on the steel enclosure, & suffice to say never tried it again. Nothing like decent, documented & controlled scientific testi
Electronics Forum | Wed Sep 12 00:42:35 EDT 2007 | duyhoang
Hi all, I've just bought a second-hand oven HVC102. Unfortunately, The Computer broke and software disabled. anyone helps me to have a new sofrware? Thanks very much,
Electronics Forum | Tue Nov 25 10:04:39 EST 2008 | wavemasterlarry
I've made storage bins made from old beer cases i had laying around. Seems to work well and I can check to see if any parts broke off b y looking at the bottom of the case.
Electronics Forum | Tue Aug 25 13:30:35 EDT 2009 | rossi
It appears that the crack is between the paste and the ball. We physically pulled off the BGA by force and almost all the balls broke at the PCB. There was a thin layer of solder left on the pad. Maybe 1% of the balls stuck to the pad. I have attac
Electronics Forum | Mon Sep 16 00:30:56 EDT 2013 | larrygroves
likely something loose in the z or theta axis. Motor overruns and is corrected but goes too far then gets corrected back. it sets up an vibration and can make a lot of noise. best guess is that the spring is broke in the z rack.
Electronics Forum | Thu Nov 05 20:53:37 EST 2015 | shuttlestar
It's a strange task . if your PCB is very very small ,using topside heat is not a big problem . but for a whole PCB board . if delete the step of preheat, it will broke the whole PCB . BTW,do you finish your task ?
Electronics Forum | Tue Jun 07 03:35:28 EDT 2016 | yuran111
yury tsupa. good afternoon. ultraflex 3000 mpm need soft. help us. we broke the hard disk in the printer MPM Ultraflex 3000. we need a copy of your hard disk this printer or software to install - distribution. cd install. Thank you. payment guarant
Electronics Forum | Fri May 25 05:44:18 EDT 2018 | ringelgr
OK guys i finally traced the error it was the R-Axis motor rolling bearing. It broke so the motor could not start.
