Electronics Forum | Mon Feb 21 20:20:01 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Mon Feb 21 20:22:29 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Mon Aug 24 07:52:23 EDT 2015 | roblackey
Can Assembleon Opal nozzles be repaired? I have > a few ith chips on the corners of the tips. It > appears as though the tips are pinned in the > bodies of the nozzles, and that they could be > changed out. Thanks > Can Assembleon Opal nozzl
Electronics Forum | Fri Aug 07 11:02:29 EDT 2015 | ehess
Can Assembleon Opal nozzles be repaired? I have a few ith chips on the corners of the tips. It appears as though the tips are pinned in the bodies of the nozzles, and that they could be changed out. Thanks
Electronics Forum | Tue Jun 28 19:56:20 EDT 2005 | matjen
I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please
Electronics Forum | Thu Feb 24 11:45:17 EST 2005 | JB
Any Universal GDM users out there, what nozzle type are you using succesfully to dispense glue on 0603's? Single or Dual tip? How about standoffs? Thanks in advance for the info.
Electronics Forum | Fri May 17 08:43:46 EDT 2013 | fredcalkins
If you have Flexhead nozzles you need to be careful that whatever solvent you use does not attack the gasket adhesive. I might try a couple of drops of a spray like WD-40 or LPS. Let it soak for a few minutes and blow it out with compressed air. Repe
Electronics Forum | Tue Apr 05 12:03:39 EDT 2022 | my3sons
Hello, we can offer you a great solution for handling these LED's which I'm betting are sticking to the nozzle after placement correct? We use a special tip material that doesn't stick...our part # 2014-2146 $450.00
Electronics Forum | Fri Apr 20 13:25:46 EDT 2018 | emeto
This one should be easy. 1. Check your nozzle - make sure you use the right nozzle and the nozzle tip is not damaged in any way. 2. Vacuum suction going to the nozzle should be measured/checked.
Electronics Forum | Mon May 21 09:04:15 EDT 2012 | cbeneat
We've had the same issue on our Panasonic CM machines with Cree XP type LEDs. Count on tools makes a urethane tip nozzle that we are using which eliminates the sticking, our concern with these is durability. Nozzle supply company makes a steel Teflo
