Electronics Forum | Wed Apr 25 15:55:20 EDT 2007 | realchunks
Yessir! I can duct tape my camera phone to the end of a broom and use that until we get some RTV (Redneck Tape Variant). Just be aware that the AOI will be down for PM, end of the day sweep ups, and incoming phone calls.
Electronics Forum | Thu Apr 18 09:20:58 EDT 2002 | huey
Having been the G.M. of Universal's remanufacturing division for 10 years I am familiar with the "Third Party Support Policy" as I was the primary author of it. The primary reason the policy was developed was to make it more difficult for other rese
Electronics Forum | Wed Nov 11 23:01:10 EST 1998 | Jason
| The only announcement that I have seen affects the line of printers (SMTech was purchased by Quad several years ago). | | is it true that Quad Systems has been acquired by Speedline? Can anyone confirm or deny this? | | | | SMTech was purchased
Electronics Forum | Mon Nov 02 13:27:17 EST 1998 | smd
| | I am looking for suppliers of through-hole DIP insertion. It's been a long while since I've looked for through-hole equipment and am not aware of who manufactures DIP insertion equipment. If you know of some suppliers, I would appreciate some i
Electronics Forum | Wed Jun 03 18:19:45 EDT 1998 | Earl Moon
| What methods do people use to dress pads after removing and before replacing the BGA? | We use solder wick and a soldering iron, focusing on not "dragging" the wick across vias. This is laborous and booring. Who has a better way? | Dave F Dave, Wha
Electronics Forum | Thu Aug 20 13:15:58 EDT 2009 | ratsalad
Yes, you should be able to. The feeder interface for the GSMs (not Advantis or Genesis) has been the same as far back as I can remember... And we used to have a D-block machine. We use some of the same feeders from that old D-block GSM on the GSM
Electronics Forum | Wed Nov 11 09:29:56 EST 1998 | Magnus Andersson
| | | I am looking for suppliers of through-hole DIP insertion. It's been a long while since I've looked for through-hole equipment and am not aware of who manufactures DIP insertion equipment. If you know of some suppliers, I would appreciate some
Electronics Forum | Mon Feb 10 21:59:25 EST 2003 | MA/NY DDave
Hi I have to laugh since this is such an old note, yet somebody found the topic useful and a guy who works in Broome County responded during lunch. Must be slow.. Hee Hee. Go over to Gary's U Pull it. I haven't done these components yet, yet at Uni
Electronics Forum | Wed Jun 03 21:51:33 EDT 1998 | Dave F
| | What methods do people use to dress pads after removing and before replacing the BGA? | | We use solder wick and a soldering iron, focusing on not "dragging" the wick across vias. This is laborous and booring. Who has a better way? | | Dave F | D
Electronics Forum | Wed Nov 28 16:08:38 EST 2007 | jmelson
I've been using Xilinx TQFP's in the 44 and 144 lead sizes with no trouble. I don't even bake them before reflow and have never had any problem. The Xilinx parts are certainly NOT sensitive, I could not break one with my bare hands if I tried (I ha
.png)
winsouce.jpg)