Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Feb 17 16:25:20 EST 2022 | mihai_voivod
I'm not understanding what roller with closed sides you are referring to. My edge roller bearing (brass color) has a lip on the side. The middle roller bearings (silver) have a slightly bigger lip. These are the roller bearing shown on the manufact
Electronics Forum | Wed Feb 16 23:26:48 EST 2022 | sarason
The question should be how does it ever stay on track. Replace the roller with one with closed sides and you wont have a problem. THe belts tension probably varies because of age and wear along its length, thus working for a few feet and then going o
Electronics Forum | Sun Jan 17 19:24:31 EST 1999 | Wayne Bracy
hey Steve Who's brush roller conveyor is that? Wayne | Hey Ya' Chrys!! | | One other thing I can think of when it comes to looking at FAB vendors to rate how good they are, might be something that you may not be too concerned with (dependin
Electronics Forum | Fri Jan 29 07:55:52 EST 1999 | Wayne Bracy
| | | | | | Greetings, | | | | | | | | | | | | Can anyone tell me what temperatures pcb's should have when coming out of a forced convection reflow oven and out of a wavesoldering machine. | | | | | | Also, is there any danger of the pcb's giving of
Electronics Forum | Tue Apr 16 19:59:32 EDT 2019 | davef
Tel: 0115 955 4506 Kinetic Conveyor & Roller Systems Unit 2 Enterprise Park Wigwam Lane Hucknall Nottingham NG15 7SZ Email: sales@kineticbelting.co.uk
Electronics Forum | Tue Jul 15 09:02:09 EDT 2008 | ehess
Has anyone using these ovens had any problems with the chain (flat) belt slipping? I suggested to the tech we remove a link in the flat chain, and he responded it would make it out of warranty. It's the same type of chain flat belt as most wash and
Electronics Forum | Mon Nov 22 10:29:18 EST 1999 | Boca
Hany, Chartrain has some good points, if you product is expensive, what does the cost of a UPS amount to? Remember, you don't want to 'back up' the heating zones, just the controller and conveyor drive system so product doesn't get stuck in the oven
Electronics Forum | Mon Mar 26 09:41:03 EDT 2018 | fuji_user_2014
Hi Gurus, Looking for alternatives to line makeup after reflow oven. Currently, I have a continuous on flat belt conveying out of my reflow oven straight to an EOL bench. The operator manually picks up the board off the belt (there is a roller at t
