Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Fri Sep 22 06:59:45 EDT 2000 | jackofalltrades
For several years now we have been using a short (4 feet) conveyor with brush wheels and a simple box fan mounted under it (blowing up) to cool the product.
Electronics Forum | Thu Aug 30 22:50:23 EDT 2012 | jeffr
Common problem. Start at the Encoder and measure the 5v square wave. Trace it back to the Frequency to Analogue converter, then to the controler. I assume that your conveyor is in good shape. i.e. With the motor disconnected, the chain should flow f
Electronics Forum | Tue Feb 17 13:04:14 EST 2015 | longnguyen
I am looking for the Manual and the Conveyor belt fluid cleaner for the Electrovert Bravo 8105, the conveyor belt fluid container is near the front with the brush point down to belt ( closed to the monitor ), any one know where can i buy this Manual
Electronics Forum | Mon Nov 01 09:56:57 EDT 2021 | richardcargill
Update - Solved On talking with BTU they mentioned that if the conveyor is always running full speed then cleaning out the motor brush area with compressed air will cure it. I'm guessing that the carbon dust had encroached onto the encoder. A good b
Electronics Forum | Sun Jan 17 19:24:31 EST 1999 | Wayne Bracy
hey Steve Who's brush roller conveyor is that? Wayne | Hey Ya' Chrys!! | | One other thing I can think of when it comes to looking at FAB vendors to rate how good they are, might be something that you may not be too concerned with (dependin
Electronics Forum | Fri Aug 28 11:59:05 EDT 2015 | gascon5383
Actually I should have noted we resolved this issue. After chasing our tails for a while, we found that somehow there was a static charge on the boards going into the machine. This static was discharging to the camera through the board stop, causing
Electronics Forum | Fri Jan 29 07:55:52 EST 1999 | Wayne Bracy
| | | | | | Greetings, | | | | | | | | | | | | Can anyone tell me what temperatures pcb's should have when coming out of a forced convection reflow oven and out of a wavesoldering machine. | | | | | | Also, is there any danger of the pcb's giving of
Electronics Forum | Thu Mar 04 10:07:46 EST 2004 | Chris Lampron
Sorry about the non SMT post, but I figured that there might be someone with a similar experience out there. We have been having a tough time cleaning the conveyor chains in our wave solder machine. We have been cleaning them in a self cleaning oven,
Electronics Forum | Fri Sep 07 16:53:37 EDT 2012 | burb1999
We have Heller, 1707EXL now. It has a removable support for the mesh conveyor that just pull out (clipped in). Had an Electrovert and they were bolted on and very tuff to change out. The oilers Im not sure I care for though,they have a metal rail t