Electronics Forum | Sun Feb 02 10:00:55 EST 2003 | davef
Mitsubishi Gas & Chemical's Bismaleimide-Triazine (BT) resin laminates are the defacto standard material for BGA. Have you checked with them?
Electronics Forum | Thu May 13 17:11:48 EDT 2004 | Longhua
We are looking for PCB suppliers capable of building .5mm through hole boards. Internally, we require 5 mil traces, sometimes 4 mil. Our preferred material is Polyimide or BT Resin, and perhaps FR408. All help and/or recommendations is greatly appre
Electronics Forum | Mon Feb 05 10:21:21 EST 2007 | davef
Thermal conductivity [W/m-�C] * Silver: 418 * Aluminum: 403 * Copper [rolled annealed]: 392 * Copper [electrodeposited]: 392 * Gold: 297 * Nickel: 90.7 * Tin: 73 * SAC: 73 * Castin: 57 * Pb37Sn63: 51 * Lead: 35 * Epoxy, phenolic: 25-75 * Conformal co
Electronics Forum | Fri Jun 01 23:57:21 EDT 2012 | bwjm
HI Guys, i am facing similar issues with this BT resin material too. PCB specs are 4 layers, Nelco400013, same Tg and Td. My PCB delam after reflow. The PCB has both side mounted with SMDs. Initial mounting on the btm side after reflow, no delam. B
Electronics Forum | Fri Dec 03 18:17:12 EST 1999 | Dave F
Dave: There's lots of stuff on the web describing BGAs. Examples are: http://www.smtnet.com/bookstore/publications/0speckdo1/s1.html http://www.smtnet.com/bookstore/publications/0shutcco1/ch1p2.html http://www.citizen-america.com/OEM/bga/process
Electronics Forum | Wed Sep 29 04:33:35 EDT 1999 | Earl Moon
| | Hi All, | | Any one experince BGA-chipset warp about 10-15mil after removing | | from PCB? | | FYI, the rework temperature for preheat was 170C from room | | temperature about 30 seconds, & BGA was removed at temperature | | between 190-200C.
Electronics Forum | Thu Jan 21 15:24:18 EST 1999 | Terry Burnette
| I have received prototype PBGA (256 pins) devices from | Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I h
Electronics Forum | Wed Nov 17 09:02:57 EST 1999 | Dave F
John: The 180 Tg point is a sweet spot for obtaining heat resistance, cost effectivly. These high technology boards provide good thermal resistance for wire bonding, direct chip attach, and BGA mounting and rework. Since these boards are harder th
Electronics Forum | Thu Dec 10 09:09:31 EST 1998 | Earl Moon
| Hi everybody? | I heard that typical FR-4 would not acceptable for BGA application. | What is the main reason? | (thermal property? or CTE?) | Sombody please answer me the requirement of PCB substrate for PCB application. | Thanks. | | Youngho Son
Electronics Forum | Wed Jun 03 07:02:25 EDT 1998 | Earl Moon
| Does anybody know if a contraption exists that will minimize a PCB's tendency to become slightly bent after reflow? We have a new product that we're planning to assemble in a couple of months. The board is 9.7" by 13.4" and it is imperitive that
