Electronics Forum | Thu Feb 09 09:36:55 EST 2006 | aj
All, I would like to find out if it is possible to adjust the cooling rate on a Conceptronic Reflow Oven Model HVN70. We do not use Nitrogen and the Cooloing system is Genesis GCM-1. From profiling it seems to be cooling too quickly. Any replies a
Electronics Forum | Fri Feb 10 09:18:04 EST 2006 | aj
is that fan speed program controlled or manually?
Electronics Forum | Thu Feb 09 09:45:50 EST 2006 | PWH
I'm not familiar with the HVN70 programming but our conceptronic oven reacts well to adjusting the cooling fan speed at the end of the oven. However, TAL will likely be affected substantially by changing fan speed.
Electronics Forum | Thu Dec 21 09:32:35 EST 2006 | Brandon
Does anyone know of a source other than speedline? I know these can be had for $100. Speedline wants $1600. It is a cooling zone blower motor for a cross blow system. Not the same blower you see on the top of the heating zones. This one mounts from t
Electronics Forum | Thu Dec 21 10:05:37 EST 2006 | realchunks
What year?
Electronics Forum | Thu Dec 21 10:20:45 EST 2006 | Brandon
serial # 11875644Where would find a year? thanks
Electronics Forum | Thu Dec 21 10:46:17 EST 2006 | Brandon
1998
Electronics Forum | Thu Dec 21 14:07:47 EST 2006 | realchunks
Sent
Electronics Forum | Wed Jan 17 21:02:48 EST 2007 | Jnet
If you are just wanting a replacement blower for your air crossflow cooling section. You should be able to purchase through Electrovert cheaper than $1600 dollars. Someone must have quoted you more than just a replacement blower.
Electronics Forum | Thu Dec 21 11:55:31 EST 2006 | realchunks
I have one form a year 2006. Uses the studds to keep track of revolutions. Four wires going to the motor.
