Electronics Forum | Thu Nov 30 16:36:04 EST 2006 | techgonecrazy
I think we can control temp... but I will have to look into it further and see. I know the ovens have flow control... but as I mentioned on the last message, our BTUs are operating off of a huge chillers on the roof of the plant.(once again, not sure
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Wed Nov 29 23:25:23 EST 2006 | fastek
Is this a recent happening or has it always occured since you got the oven?
Electronics Forum | Thu Nov 30 12:30:59 EST 2006 | cyber_wolf
Increase your PM frequency........???
Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr
One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
