Electronics Forum | Thu Aug 29 13:30:36 EDT 2019 | emeto
If quality or Reliability is the key.... BTU, Soltec Vitronics..Rehm... If it is the money ...probably not these brands.....:)
Electronics Forum | Tue Oct 02 07:48:16 EDT 2007 | brendansales
Hi there, Does your computer has a product key (USB) by any chance? there are some units that requires a USB key. alternatively you can check if the controller has been opened before (you can check if the sticker has been torn), or you can try swit
Electronics Forum | Thu Aug 29 15:51:21 EDT 2019 | spoiltforchoice
&gt; If quality or Reliability is the key.... BTU, <BR> &gt; Soltec Vitronics..Rehm... If it is the money <BR> &gt; ...probably not these brands.....:) <BR> <BR> Well I
Electronics Forum | Tue Oct 02 10:01:15 EDT 2007 | chrisgriffin
I once had a similar problem on a VIP98. The problem was with the FCU (furnace control unit). There was a burned IC on the lower left of the card. I don't remember what kind of part it was, only that it was very common and I got a new one from Dig
Electronics Forum | Sat Mar 06 10:25:55 EST 1999 | Earl Moon
I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. Concerning the BGA stuff, I'm getting about 60% success using this rewo
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Tue Apr 27 05:23:29 EDT 1999 | Earl Moon
| Dave said: | | | | So Earl, have you gone honest and haken a real job or is this a consulting project? | | | | | | TTYL | | | | | | Davebert | | | | | | | | DamnDaveBert, | | | | I know you didn't mean to insult such a sensitive one as me, bu
Electronics Forum | Mon Apr 26 21:50:32 EDT 1999 | Dave F
Dave said: | | So Earl, have you gone honest and haken a real job or is this a consulting project? | | | | TTYL | | | | Davebert | | | | | DamnDaveBert, | | I know you didn't mean to insult such a sensitive one as me, but putting honesty and re
Electronics Forum | Mon Mar 08 20:17:41 EST 1999 | Michael Larsen
| | I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. | | Concerning the BGA stuff, I'm getting about 60% success using
Electronics Forum | Sat Mar 06 12:33:21 EST 1999 | Dean
| | I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. | | Concerning the BGA stuff, I'm getting about 60% success using
