Electronics Forum | Fri Dec 22 09:19:11 EST 2006 | simonlee
Our VIP98 oven just refused to do anything this morning, no previous history of problems. Conveyor and heaters do not start up. None of the Solid State Relays in the back of the unit are operating, although we can make them switch by wiring up to t
Electronics Forum | Thu Aug 29 15:51:21 EDT 2019 | spoiltforchoice
&gt; If quality or Reliability is the key.... BTU, <BR> &gt; Soltec Vitronics..Rehm... If it is the money <BR> &gt; ...probably not these brands.....:) <BR> <BR> Well I
Electronics Forum | Thu Apr 27 04:52:06 EDT 2006 | slaine
Ive a 5 zone vip 90, running at temperatures up to 280 degrees, biggest problem we have is with the fan moters siezing up. think we must have changed 8 out of 10 of them ok there 10 years old but it can be a lot of hastle. they sieze absolutly solid.
Electronics Forum | Sun Jun 10 12:15:37 EDT 2001 | procon
Hello Danial, Leave it up to most to blame the relow oven for their tombstoning problems when in fact it is usually the last to cause it. The biggest culprit of tombstoning is the pad design followed by the print quality. Usually, we find that the p
Electronics Forum | Tue Oct 18 17:06:04 EDT 2005 | stepheniii
At one time I could show you the spacing of the chain of an electrovert but the burn marks have dissapeared. The center support chain would wrap around and jam up and with boards in the oven.............. On that one for some reason we bought it wit
Electronics Forum | Thu Jan 04 15:39:49 EST 2007 | realchunks
Is it a failure or a schedule overdue? If it's a failure check the vacuum sensor in the exhaust. You should be able to locate the straw and follow it back to the diaphragm. You can adjust the diaphragm. Or you can electrically jumper past it.
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Mon Jun 14 11:39:29 EDT 1999 | Marshall
| | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from m
Electronics Forum | Thu Jun 17 10:37:42 EDT 1999 | Brian Wycoff
| | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from
Electronics Forum | Thu Jun 17 11:18:03 EDT 1999 | Ian Clelland
| | | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down fr
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
