Electronics Forum | Wed Jul 13 07:46:22 EDT 2005 | ajaydoshi
We have BTU oven150 paragon. Want to buy new cooling fan with mettal blade Part number is 5061761. Any supplier recommdation. Parts from BTU very expensive ajay
Electronics Forum | Thu Nov 30 10:38:39 EST 2006 | billwestiet
You are cooling too fast, and some flux and paste is worse than others... Can you control your cooling zones? Water Temp (higher)? Or Water Flow (less, effectively less cooling)? Changing water temp is prefferable over flow if you can do it. I h
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
Electronics Forum | Tue Sep 20 04:28:31 EDT 2005 | Rob
Pyramax 150 is a low cost newer version of the Paragon 150, the Paragon is a newer version of the VIP. The VIP is great for lead free (as confirmed to us by BTU, who told us it was pointless upgrading that particular oven to a Pyramax). You may nee
Electronics Forum | Mon Apr 24 19:18:40 EDT 2006 | sessioc
OK guys here is the skinny..... > > We need an > oven that can handle lead free temps without > slowing the belt speed under 28 or so in. per > min. > > BTU tells me that they don't recommend an > oven that maxes any less than 350 C. > > Is an
Electronics Forum | Mon Aug 25 02:57:43 EDT 2014 | arjunkolavara
We are in the process of qualifying our SMT lines for the High Melting Point Solder with alloy composition of 93.5 Pb 5 Sn 1.5 Ag.If any one has already an experience with this alloy,kindly do give ur inputs on the process of profiling . The reflow d
Electronics Forum | Fri Aug 11 00:51:41 EDT 2023 | ttheis
Have you tried asking your paste supplier about this issue?
Electronics Forum | Fri May 24 08:46:07 EDT 2024 | baronfferzog
Have you tried cannacraftcorner asking your paste supplier about pureplantpleasures this issue?
Electronics Forum | Wed Aug 09 12:11:44 EDT 2023 | thecolonel97
We are currently experiencing an issue with one of our reflow ovens producing large amounts of flux crystals in the end of zone 12 and entrance of cooling zone. This has been going on for roughly around 4 years now, we are using Senju M705 lead free
