Electronics Forum | Thu Sep 16 11:40:32 EDT 2010 | ccouture
Have you contacted BTU? They will be able to supply you with the setup files of your oven if you provide them with the serial #. Did you buy the oven used?
Electronics Forum | Mon Oct 17 09:53:58 EDT 2005 | rlackey
BTU have been around since the start of SMT, with ancient TRS14's still running today with no problems, and bucket loads of VIP's, Paragons & Pyramax's doing good service. Wouldn't use anyhting else (Did like the new Vitronics-Soltec, but couldn't b
Electronics Forum | Mon Aug 25 02:57:43 EDT 2014 | arjunkolavara
We are in the process of qualifying our SMT lines for the High Melting Point Solder with alloy composition of 93.5 Pb 5 Sn 1.5 Ag.If any one has already an experience with this alloy,kindly do give ur inputs on the process of profiling . The reflow d
Electronics Forum | Tue Aug 22 15:22:46 EDT 2023 | thecolonel97
Our paste manufacturer failed to respond. I did try adding 2 frozen jugs of water into the reservoir tank, this did not lower the cooler 1 temp. We have to have a water or air flow restriction causing this to run hotter. Still currently investigat
Electronics Forum | Fri Feb 24 13:48:33 EST 2006 | chris
Does any body know how to change the inner width limit on a P-98 BTU oven? The inner limit is 6 inches, but I need it to be about 1.5 inches. Do you have to have a factory service disk from BTU to gain access to the limit. If so, does anyone have
Electronics Forum | Thu Apr 07 10:39:36 EDT 2005 | geb
I have a BTU International VIP98 reflow oven, running WINCON Version 2.00C on Windows 98. The light tower only lights green when the oven reaches temperature, and the other colours never light up. Do you know how to set the other colour lights to tu
Electronics Forum | Wed May 24 13:10:28 EDT 2006 | Chunks
VIP 98, I believe that's a 7 zone if I can remember 6 years ago. Try 150, 165, 200, 235, 235 and 235 (top and bottom temps) with a belt speed of 35 inches per minute. This should get you in the ball park depending on the size of your board.
Electronics Forum | Mon Aug 27 12:33:46 EDT 2007 | emilio1
Hello everyone; I was wondering if anyone has/knows where to get, VIP98 FCU calibration procedure. I know its a long shot but need to calibrate a few ovens and we�d like to see if its possible to do this in house, as we have a calibration lab.
Electronics Forum | Wed Dec 27 10:55:47 EST 2006 | SWAG
I don't know much about BTU but we had a very similar problem with a Conceptronics and it turned out to be one of the 120V power supplies. Our machine had two of them (the same as you would find in any PC). Easy to test them although they can be fl
Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
