Electronics Forum | Fri Aug 11 00:51:41 EDT 2023 | ttheis
Have you tried asking your paste supplier about this issue?
Electronics Forum | Fri May 24 08:46:07 EDT 2024 | baronfferzog
Have you tried cannacraftcorner asking your paste supplier about pureplantpleasures this issue?
Electronics Forum | Fri Aug 11 00:53:33 EDT 2023 | thecolonel97
I actually just sent an email today to our paste provider ECO Solder/Senju to get their input as well.
Electronics Forum | Tue Jun 04 11:17:39 EDT 2019 | dman97
Does anyone have a manual for a BTU PYRAMAX 150N X5 oven? We recently got one of these used and it has the flux management system attached along with a water chiller. We hooked everything up, but the oven throws a water supply problem alarm. Chill
Electronics Forum | Wed Aug 23 14:58:38 EDT 2023 | markhoch
I was at our local SMTA Michigan Chapter Tech Forum & Tabletop Expo last week and BTU was introducing a new option designed to reduce flux build-up in the heating zones. Might not be a bad idea to reach out to them to learn more about it. Just a sug
Electronics Forum | Mon Aug 25 02:57:43 EDT 2014 | arjunkolavara
We are in the process of qualifying our SMT lines for the High Melting Point Solder with alloy composition of 93.5 Pb 5 Sn 1.5 Ag.If any one has already an experience with this alloy,kindly do give ur inputs on the process of profiling . The reflow d
Electronics Forum | Tue Aug 22 15:22:46 EDT 2023 | thecolonel97
Our paste manufacturer failed to respond. I did try adding 2 frozen jugs of water into the reservoir tank, this did not lower the cooler 1 temp. We have to have a water or air flow restriction causing this to run hotter. Still currently investigat
Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
Electronics Forum | Wed Aug 09 12:11:44 EDT 2023 | thecolonel97
We are currently experiencing an issue with one of our reflow ovens producing large amounts of flux crystals in the end of zone 12 and entrance of cooling zone. This has been going on for roughly around 4 years now, we are using Senju M705 lead free
| 1 |
winsouce.jpg)
