Electronics Forum | calum23 |
Fri Feb 12 02:55:13 EST 2021
Electronics Forum | Tue Oct 02 07:48:16 EDT 2007 | brendansales
Hi there, Does your computer has a product key (USB) by any chance? there are some units that requires a USB key. alternatively you can check if the controller has been opened before (you can check if the sticker has been torn), or you can try swit
Electronics Forum | Fri Dec 22 09:47:18 EST 2006 | realchunks
Check your battery back up if you have it. If I remember correctly, you may have to manually switch your wiring to by pass a dead battery back-up.
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Fri Dec 22 09:19:11 EST 2006 | simonlee
Our VIP98 oven just refused to do anything this morning, no previous history of problems. Conveyor and heaters do not start up. None of the Solid State Relays in the back of the unit are operating, although we can make them switch by wiring up to t
Electronics Forum | Mon Dec 25 12:17:57 EST 2006 | KEN
first, does the recipe have the heat and conveyor boxes checked? If no then it does nothing. second, have you pressed the round green switch? third, are there any alarms in the alarm box? Do you have a controller link fail? Verify the cable is p
Electronics Forum | Mon Sep 13 15:47:44 EDT 2010 | dox
Somebody pressed the system set button and now the machine has an e-stop,lid open, and extraction error. checked the control relays and all is OK except one is not switching on. The cable comes from the FCU unit so suspect some config or settings are
Electronics Forum | Tue Apr 25 01:23:28 EDT 2006 | kanna
Thanks. currently we already reduce the temperature and change the bimetallic switch. can anyone help me on the alert problem. the alert trigger when the zone 1 section empty without board. current temperature setting is 187 even i lower the tem or i
Electronics Forum | Wed Apr 14 17:39:20 EDT 1999 | Dave F
| Can someone explain the difference between solder "fines" and solder balls? Is there an official specification where "fines" are defined? What is the spec for "fines"? | | I consider "fines" individual unmelted metal spheres that are found in s
Electronics Forum | Thu Apr 15 12:58:59 EDT 1999 | Chrys Shea
| | Can someone explain the difference between solder "fines" and solder balls? Is there an official specification where "fines" are defined? What is the spec for "fines"? | | | | I consider "fines" individual unmelted metal spheres that are foun
