Electronics Forum | Tue May 20 04:34:59 EDT 2014 | sarason
Well that would be a response from the VME bus. Is the PCBoard, the only controller on the buss, or is there a second controller that talks to interface boards etc. If so you might just have a problem with the second controller. Check the control sig
Electronics Forum | Thu Dec 19 10:53:15 EST 2019 | kithnelso
Can any one tell me what I would need to replace this yellow disc. I have another board that this part has burned up, and I need to find a replacement. The manufacturer is Buss, however I cannot find any information with the numbers printed on it. Th
Electronics Forum | Mon Feb 20 14:56:22 EST 2012 | acsscott
Ok, so we figured out that if the LCS is connected, we don't get the error. So, the HDLC data buss gos out and back, or is terminated in the LCS. How to remove the LCS? We try to go into maintenance screen to change the machine configuration, and
Electronics Forum | Tue Oct 19 17:52:47 EDT 1999 | John Thorup
Hi Carol You can use a threaded standoff and put a screw through the board and into the standoff with the screw from the buss bar coming into the other end of the standoff. You should use a SEMS type screw or a internal star type lockwasher with a pl
Electronics Forum | Mon Aug 27 14:23:45 EDT 2007 | scooter
I must be missing something? If you strip 1/8" off both ends of a 1/4" long wire you would have nothing left? Anyway I would use buss wire and if needed slide a bit of tubing over it bill
Electronics Forum | Mon Apr 25 15:58:15 EDT 2011 | davef
There is no advantage for fabricators or assemblers. In high speed memory busses, designers zigzag the traces to keep all of the traces within a certain length of each other.
Electronics Forum | Thu May 22 03:27:58 EDT 2014 | sarason
Its hard to tell, from this distance.Try and find yourself a good tech in your area. I sometimes find them fixing Mobile phones and TV sets. There would not be too many of us still fixing VME buss systems. Where are yu located? sarason
Electronics Forum | Tue Feb 18 18:33:57 EST 2020 | jerlong2020
I have used infrared imaging to find electrical shorts on logic boards between the 5 Volt buss and ground. You can power the electrical short up to draw 50 to 100 mA and then look for the warm spot in the infrared display.
Electronics Forum | Tue Nov 28 17:23:03 EST 2006 | flipit
Flash gold usually refers to electrolytic gold with a short plating time. In other words gold plating that requires current to plate. If you have bare copper under your soldermask, the gold is probably ENIG. The only other way to have bare copper
Electronics Forum | Fri Oct 26 09:43:19 EDT 2018 | dnachristen
Hello! A member here graciously sent me the pinout I needed. I now have 24v to the feeder in the test rig, but need to know what type of signal the feeder requires on pin 9 to electronically index. Anyone have a clue? I tried ground signal and 24v, n
.png)
