Electronics Forum | Wed Feb 21 09:36:10 EST 2007 | hanza
Hello, We are planning to buy a desktop AOI system and were able to experiment with a Mirtec MV-2 system. Results were pretty good, except for some types of solder inspection. I am wondering if anyone has some experience with the Mirtec MV-3 (3D 5-
Electronics Forum | Fri Apr 13 08:21:37 EDT 2007 | Mark
Hello, what robot did you buy? regards Mark
Electronics Forum | Wed Mar 28 10:10:49 EDT 2007 | Mark
Hello, Thank you for informations. What about no contact laser robot system is it worth to investigate these solutions? Regards Mark
Electronics Forum | Thu Nov 13 09:35:51 EST 2008 | djames
Hi Lozie, Picked up your thread about Apollo Seiko robot. We have a bespoke system using the Luna L model (point soldering). Who is the expert at apollo for setting up parameters etc., We are having trouble soldering links (smt pads). Regards Dave
Electronics Forum | Wed Mar 28 08:34:31 EDT 2007 | Mark
Hello, I am trying to find out your opinion about using soldering bench top soldering robot to solder THT connectors (diffrent). What is your experinces and what is limitation for this system. We can't use wave soldering machine due to the complex
Electronics Forum | Wed Mar 28 10:58:13 EDT 2007 | rlackey
Hi Mark, When we last checked out the laser systems you had to either use a solder preform or apply solder paste to the area, which meant either dispensing or some clever printing. Cheers, Rob.
Electronics Forum | Wed Apr 11 16:09:16 EDT 2007 | egrice
Robot soldering has never really worked well and if you are looking for any volume or repeatability, you may be disappointed! Even though you are using a robot, you are still soldering with an iron and wire solder. This process cant guaranty the be
Electronics Forum | Wed Mar 28 09:32:27 EDT 2007 | realchunks
Solder iron robots tend to miss solder joints from time to time. The wire feeder systems are the key to these machines. Most use the edge of the board for alignment is another reason they miss. If you have SMD close to the thru-hole, the robot may
Electronics Forum | Wed Mar 28 12:46:50 EDT 2007 | realchunks
Rob is right, you do need to dispense paste or pre-forms when using a laser. Although the Panasonic Soft Beam has a wire despenser. I've seen laser soldering and it does work on smaller stuff. Doesn't work well on connectors even after preheating.
Electronics Forum | Sat Apr 14 08:23:29 EDT 2007 | davef
Laser soldering suppliers are: * Seica [low cost firefly A-30]; 45 Osgood St 1st Flr, Methuen, MA 01844; 978-683-8356 F8357 seicatestsolutions.com/pages/24/A30-Firefly-Solder-Station.php; Dave Sigillo [GM] sigillo@seicausa.com * Leister Process Tech
.gif)
winsouce.jpg)