Electronics Forum | Thu Feb 16 12:16:36 EST 2012 | jax
I would assume every EMS company runs into this issue on a daily basis. Before we get to how a machine handles it, I would recomend setting up an acceptance criteria with your board supplier... if you plan on accepting them at all. (ex. No more than
Electronics Forum | Wed Dec 19 21:21:02 EST 2012 | davef
MosheSh: When it comes to ground planes, most designers are out over their skis. They don't understand what's going on or how it affects their design. So, they get massively conservative about the number of plane layers, whether they can be hatched o
Electronics Forum | Tue Sep 20 14:36:53 EDT 2022 | sarason
Have you considered using PCBSYynergy for the CAD conversion and bypass the gerber step. Then add in Programming by Ealead. https://ealead-e.ucoz.com/index/products/0-8 https://pcbsynergy.com This ends the breaking of QC by bypassing human process
Electronics Forum | Fri Jun 15 09:59:29 EDT 2001 | brownsj
We have recently had an incident where we feel that we have received a batch of cards from our assembly house which have by-passed their ICT operation. This has been determined by the lack of any indentations on the test pads from the sprung probes.
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Thu Feb 05 19:45:33 EST 2004 | davef
Sure, here's one: Micro-Screen; 1106 S High St, South Bend, IN 46001; 574-232-4358 Fax: 574-234-7496; Cathy info@microscreen.org http://www.microscreen.org We list the following company in our notes, but have never used them: SEFAR AMERICA - MEC P
Electronics Forum | Fri Oct 18 15:29:16 EDT 2019 | kylehunter
Hi all. We are currently trying to build a downstream bypass to have our final conveyor feed into our oven, which doesn't have a SMEMA interface. Right now we have to manually connect the two downstream ready pins by hand. I have a good idea of how I
Electronics Forum | Fri Feb 13 09:19:12 EST 1998 | Jimmy Blier
Hi! I'm looking to find a training course for PCB design & layout. It would be prefer to be in Canada, if such courses are available here... if not I'll go where ever I have to. The course should be about the following points or more: -Crosstalk -cou
Electronics Forum | Sun Feb 15 10:47:16 EST 1998 | SMT-ASSY
In reference to your Email response, we will propose to you in the next few days a course curriculum which we hope you will find of great interest. As we told you we offer courses for assemblers and techs in PTH, SMT soldering, SMT full process using
Electronics Forum | Fri Feb 13 12:48:24 EST 1998 | Scott Cook
| Hi! | I'm looking to find a training course for PCB design | & layout. It would be prefer to be in Canada, if such | courses are available here... if not I'll go where ever | I have to. | The course should be about the following points or | more: |
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900