Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Fri Oct 28 04:14:18 EDT 2011 | kenmar
I have a loud humming noise coming from my MY12 X-Motor ( Like when a motor is not locked in and it hunts). This noise is not all the time but only sometimes especially with fine placement!! What can it be? I do not want to change the Motor to find o
Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Wed Aug 04 08:40:37 EDT 2010 | keiths487
I used to wrench on those all the time! I really > should be more help to you but it was a few years > ago... A few more things to check - clean the > line sensors on the back of the machine. Check > to make sure you don't have a feeder that i
Electronics Forum | Sat May 28 12:01:13 EDT 2005 | KEN
I have had two of these machines in the past. From what I can remember... Z-axis: Bad Sound going down...probably belt is out of time and is binding or a bad stepper motor. Bad sound going up...could be belt timing or a bad stepper motor. Bad mo
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Fri Aug 18 14:31:53 EDT 2006 | vikkaraja
I have humming noise comming from my Z axis motor for a while now. It faults out every so often, but not enough to stop production. I even can hear it while machine is in normal production mode. I have replaced the z servo amp. It did not help any. O