Electronics Forum | Thu Apr 12 13:44:21 EDT 2018 | coradias
Hi...i am a new user here. As per my knowledge 20 inch wide boards will probably be your most limiting factor most large board variants increase the length they can handle and stop at 460mm wide.
Electronics Forum | Fri Jan 26 08:28:59 EST 2001 | Sal
I am currently in the Process of setting up some SPC software on our Wavesoldering equipment. What I would like to know for each Parameter that is listed below what kind of variation from my average setpoint would cause defects.Example. If the averag
Electronics Forum | Wed Apr 14 17:14:49 EDT 1999 | Stephen Oltmann
Check with BTU. They have dryers in the length you need. Good luck! | | I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches
Electronics Forum | Tue Oct 27 12:31:24 EST 1998 | Sanjay Bhatikar
SMT-ers I notice that most suppliers provide data that is eye-catching but avoid providing data of significant technical relevance, such as Cp and Cpk. It would perhaps be a wise idea for standards to be formulated in this area. For eg., ma
Electronics Forum | Thu Feb 15 16:01:53 EST 2007 | jdengler
Bert, Clean the emitter disk of the nozzle you use for this part. Set everything in the PD back to where it should be and set the "Lead_check_area" to 10. This will look at 10% of the end of the leads. This will help if the leads do not have even
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Tue Apr 13 23:27:34 EDT 1999 | Mike Flori
I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consider
Electronics Forum | Wed Apr 14 17:13:08 EDT 1999 | Stephen Oltmann
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
Electronics Forum | Tue Oct 12 13:40:14 EDT 2004 | Jimmy
We recently went through an evaluation period of an NXT modular setup. We ended up purchasing the 2XM6 setup mainly due to the board length limitation of less than 10 inches for the M3 modules without splitting feeders. The machine has been extremel
