Electronics Forum | Wed Jul 24 10:57:32 EDT 2019 | aharper
We recently acquired an EKRA E5 (vintage 1999), and I am receiving a "Machine Offline" error. I discovered a cable labeled "X20b" that is disconnected, but I cannot find the port it should be connected to. I do have the manual but have not found any
Electronics Forum | Sun Jan 27 11:28:42 EST 2013 | mdang
Could anyone help to connect a FUJI CP42 machine to a conveyer with stanard SMEMA? CP42 has 2 wire cable and small female connector label SMEMA (Not fit with stanard SMEMA). Thank you for all your help, -Michael
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Fri Dec 29 15:02:33 EST 2006 | bman
We build quite a few cables ourselves, and we go through a lot of heat shrink labels. Unfortunately, we only use Brady heat shrink labels, so I don't know if I can help much. Are you actually running raw heat shrink through your printer? If so, go
Electronics Forum | Mon Mar 21 09:33:25 EST 2005 | davef
RoHS Substance||RoHS MCV Limits||Typical Testing Approaches Lead||1000 ppm* ||Wet chemical digestion followed by ICP (Inductively coupled plasma) or AAS (atomic absorption) spectroscopy ||||XRF (X-ray fluorescence) spectroscopy Cadmium||100 ppm ||Wet
Electronics Forum | Wed Sep 22 12:23:11 EDT 2004 | Peter Barton
FYI Label on the back of my charger says the following: Pt. No. WD23D200KCN PSU E31-0900-21 Input 230 V AC Output 9V DC, 0.2A 1.8VA Ours is of course United Kingdom type, even if the mains plug is European and requires an adaptor. Not too sure a
Electronics Forum | Fri Feb 14 16:01:28 EST 2020 | bk
On the my12 the panel on the front of the machine comes off two screws each corner to loosen the panel. There is a pull out tray that gives you easier access to the computer, ps3, etc. It will be the box in the center on top it should label where eac
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Mon May 07 16:49:59 EDT 2001 | davef
Ashok, What in earthly heaven does this question have to do with "site support"? You can�t always get what you want, but sometimes you get what you need. Some leads are: * The proposed IPC cable/wire harness document is now IPC/WHMA-A-620 and go
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
.gif)
