Electronics Forum | Thu Sep 08 18:01:22 EDT 2011 | comatose
We had a camera die on one of our GSMs. I got a new camera, and it is working, but I need to either find a cal kit to rent for a day, or else if someone knows a reasonably accurate procedure to calibrate the new camera using the other upward looking
Electronics Forum | Fri Jan 27 09:00:14 EST 2012 | davef
A thermocouple is a set of two wires welded together at one end, where a junction is formed between the two wires. Because each wire is composed of a different type of metal, each wire reacts differently to the temperature of the junction. Because of
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
Electronics Forum | Thu May 10 09:57:22 EDT 2001 | zam_bri
Hi Cal/Dave F, Good news today. The problem went away when I received and ran with a brand new component today. But I'm sure with a robust profile, I should be able to compensate oxidations at some degrees, rite? ( taking into consideration the suc
Electronics Forum | Mon Jul 21 09:34:54 EDT 2003 | caldon
A machine for serious concideration MRSI 175uf Features: -High-throughput Underfill -Parallel Processing Conveyor Lanes -Linear Positive Displacement Pump -Total Process Thermal Control -Intuitive Graphical User Interface - Windows NT -Advanced
Electronics Forum | Tue Jul 27 19:02:46 EDT 2004 | pdeuel
Not an easy task and requires calibration jig. MPM support field service is your best bet. The adjustment screws for the prizm located on left side of camera will adjust the x direction. There is a set screw on the front that must be loosened first.
Electronics Forum | Fri Dec 22 16:58:38 EST 2000 | LarryK
Lee, Cal is correct in that Jafco makes the fingers you described. If i remember correctly, they were located in Texas. I had them on an Electrovert in my previous employer. They were about 50% of the cost of the Titaniums. They had their good and ba
Electronics Forum | Fri Dec 22 09:39:22 EST 2000 | CAL
Some random Ideas when I read you post...... 1) If it works don't fix it. 2) Be aware of the temp threshold of your components....Over heating components is not good. Over heating is not good period. 3) The Solder paste Chemistry you are using maybe
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
.png)
