Electronics Forum | Fri Apr 10 09:59:13 EDT 2020 | spoiltforchoice
> We unfortunately use GERBER data to digitize <BR> > boards more than any CAD. We are CM and many of <BR> > our customers do not provide CAD. With some <BR> > Legacy products, we still use 274-D Gerbers
Electronics Forum | Tue Apr 23 04:44:26 EDT 2019 | gfe
Good morning guys, calibrating the cameras in smt machines Mirae mx200l and mx200lp, anyone know?
Electronics Forum | Tue Oct 15 03:57:02 EDT 2019 | kartaviiork
Hello, i am have experience in calibration by hand by input to offsets (some times jigs are not perfect). Also I could try to answer to some questions about Mx Mr Mirae series.
Electronics Forum | Wed Jan 08 06:13:55 EST 2020 | raeesrajput
Hi, Can you please guide me how to calibrate 'The hole location'. Which can be done in the “ANC..” menu. I am using Mirae 350 machine. Best Regards, Raees
Electronics Forum | Thu Jan 09 08:40:37 EST 2020 | raeesrajput
Hi Every one, Thanks in advance for your help and support. I am getting errors 'Nozzle pick up error' and 'Nozzle release error' on Mirae Mx350. I have been told to calibrate Nozzle Holes using 'ANC' option in the Menu. Ther
Electronics Forum | Thu Feb 08 07:57:33 EST 2001 | CAL
DAVE F. Far be it for me to correct you, it is not my place. I just want to Calibrate your GPS a little. The short and sweet version- Quad was to sell Samsung machines under a private label. All was ok until Quad released a machine to compete with Sa
Electronics Forum | Wed Apr 24 07:06:56 EDT 2019 | griinder
You need two calibration jigs to calibrate these cameras. There is an L-Type align offset jig that involves removing the front feeder base, and placing the target dot over the middle camera of your front camera bank. After this calibration is done, t
Electronics Forum | Thu Aug 10 16:34:18 EDT 2017 | kalsi311
Thanks for quick reply We were using 2 MR40LS machines and 1 MR20LP machine. MR40LS machine have tow beams and 12 heads (6 heads each) and MR20LP have 4 heads. In my new company we are using 2 lighting head who have 30 heads and 1 7 heads machine. B
Electronics Forum | Thu Jun 20 05:09:41 EDT 2002 | mattiasw
I am running a VisionPoint AOI equip. from DiagnoSYS, and I have a question regarding the calibration of brightness on the cameras. When I run system Calibration to check the camra brightness I should have the following values: Cam#1=126 Cam#2=126
Electronics Forum | Wed Apr 24 07:16:50 EDT 2019 | griinder
Here is a newer procedure I found, that is more in depth with better illustration. The nozzle jig, is also used for proper Z calibration, and is pictured in this service procedure.
.gif)
