Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Wed Nov 20 10:21:09 EST 2013 | cyber_wolf
Station 17 and 19 errors are almost always caused by dirty clutches or bad sensor dogs. My guess would be bad sensor dogs in this case if it only does it on certain jobs. The reason it happens on those jobs is because there are nozzles being indexed
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Wed Aug 10 09:56:09 EDT 2022 | jojoled
Hi guys, from certain time (not sure, but it could be power down last week) none of the 2 heads can succesfully pickup nozzle from ATC (after startup calibration is done, but in the calibration sequence the ATC height is not measured, it just calibra
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Wed Jun 10 01:35:07 EDT 2015 | leeg
Does head 7 calibrate ok? Is it a bent shaft?
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Thu Jun 15 14:20:21 EDT 2000 | Kevin Simpson
Hi Peter, The Disk you are refering to can be outsourced from several different vendors. The thing to be careful with is getting a consistant colored disk. You don't want to have etc... some dull/bright..etc. We have found one local vendor we use.
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
winsouce.jpg)
