Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Sat Mar 27 23:03:21 EDT 2010 | dman97
Well I'll be damned! I was printing this on the fiducial side. Silly me. I should have read the manual closer. Thanks for the help.
Electronics Forum | Tue Sep 29 20:44:36 EDT 2015 | dekhead
I can probably help you with manual and prints. Please contact me directly. www.dekhead.com
Electronics Forum | Fri Mar 26 21:48:56 EDT 2010 | dman97
Can someone explain to me what I'm supposed to do after I have done the vision offset calibration procedure? The manual tells me to put solder paste down on all 25 holes of the stencil. After this the board drops down and the machine scans each fidu
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Mon May 05 08:42:35 EDT 2008 | mmjm_1099
We use double image stencils with our DEK Horizons. My operators would just load the pcb on to the rials and manually adjust the stencil and clamp it. Once they do that they add into the comments what number the handcrank adjustable is at so next tim
Electronics Forum | Sun May 04 19:18:42 EDT 2008 | dman97
Hi all, I recently acquired a year 2000 dek 265 horizon. It has a manual screen loader with that stupid hand crank adjustable stopper. Can anyone tell me how I am supposed to measure the stencil image dimensions for a front justified stencil? Now on
Electronics Forum | Sat Nov 09 20:00:24 EST 2019 | richardcargill
Yeah, sorry, just noticed that bit on the photo. I'll have to have a look at my machine on Monday to see if there's anything that might explain it. The pressure system is pretty much the same on all the 265 variants so if you can find a service manua
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
