Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Wed Jun 09 16:54:24 EDT 2004 | Ralf
Hi all I have a question to all of you who has experiences with Microflex MPM. There are two items: one is on contact calibration and second squeegee pressure calibration. Do i have to if i set PCB make these calibration?. Does Microflex have mechani
Electronics Forum | Mon Jan 07 08:23:37 EST 2013 | cyber_wolf
You should be able to find this in the utilities menu under calibrate machine. (If your software is the same as my Momentum) If not, give MPM service a ring. They will help you.
Electronics Forum | Fri Jan 04 13:47:00 EST 2013 | cyber_wolf
If its the same as a Momentum then no you do not need to use jigs. There is a "global offset" field that allows you to add background offsets. The glass plate jig calibration procedure only needs to be used after a major crash or if you feel the need
.gif)
