Electronics Forum | Thu Dec 11 00:00:22 EST 2003 | david2002
Does anybody have the measurements for the dimensions of the CyberSentry fiducial calibration board. This is a board used to set the machine up if paramter files are lost. Our board has gone missing and cyber optics has a long lead time. We can easil
Electronics Forum | Thu Jan 04 03:01:38 EST 2018 | buckcho
As always, our good colleague Evtimov is right about the AOI and oven. For the AOI you need to make a golden sample board(panel) and test if your machine can catch all defects that you simulated BEFORE the oven. Try to me as accurate to real defects
Electronics Forum | Thu Mar 30 09:54:28 EDT 2017 | max83
Hello all, Does anyone know when can we take Calibration PCB for SyberOptic QX100
Electronics Forum | Thu May 05 12:30:48 EDT 2005 | jsk
Align the optics (calibrate) Who can provide this service? (other than the manufacturer) Thanks,
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Tue Apr 20 17:20:56 EDT 2010 | davef
You should check the optical alignment and thermal calibration of the BGA rework station periodically [every six months]. Likely, the equipment supplier gives recommendations on this calibration effort, maybe in the manual.
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Wed Aug 20 18:17:56 EDT 2003 | stefwitt
I guess we should differentiate between machine calibration, process reliability measurements and process capability study. For the machine calibration you use the machines own optical cameras, but for cpk or standard deviation you measure the place
Electronics Forum | Tue Jan 04 15:33:05 EST 2005 | davef
We seemed to replace a lot of optical couplers and absolutely hated that the calibration instuctions in the manual were not translated from German. [Got politely escorted from the Novastar Booth at a trade show for complaining to the company preside
.gif)
