Electronics Forum | Thu Apr 15 11:53:37 EDT 2004 | Claude_Couture
Hi everyone, Our QC manager is bugging me about calibrating the TC readings on our reflow ovens. I keep telling him that doing a regular reflow profiling with a mole is sufficient to see if the oven temperature are normal. The manuals state that TC c
Electronics Forum | Sun Jan 15 10:36:23 EST 2006 | Robert
Oven runs, input/output sensors work but no product tracking. Various resets have no effect and cannot reset Drive Cycle Timer due to "not calibrated" error. Where can I find the procedure without manuals on-hand?
Electronics Forum | Thu Jan 08 16:21:05 EST 2004 | Bill
James: The ovens can be calibrated to help get this a little closer. In the computer box are 3 cards (alike) attached to the motherboard. They are called IPS-7 cards. On these cards are 2 potentiometers to calibrate the T/Cs for the heat zones. There
Electronics Forum | Mon Feb 04 10:17:39 EST 2008 | slthomas
Your oven no doubt compensated by reducing energy to your heaters so it might not be as bad as you think. I'd be more concerned about even heating than over heating. My opinion is that an out of calibration profiler result is better than no result
Electronics Forum | Fri Feb 10 11:33:32 EST 2006 | fredericksr
I am putting together an internal oven calibration procedure. I am interested in how stringent your oven calibration process is. Really what I am putting out is a verification process and a calibration process for the event that verification should
Electronics Forum | Mon Aug 27 12:33:46 EDT 2007 | emilio1
Hello everyone; I was wondering if anyone has/knows where to get, VIP98 FCU calibration procedure. I know its a long shot but need to calibrate a few ovens and we�d like to see if its possible to do this in house, as we have a calibration lab.
Electronics Forum | Fri May 13 18:17:33 EDT 2005 | pde
The encoder is a sealed encoder located on the down stream end of the oven. Call Vitronics / Soltec for tech support. There is a calibration procedure for adjusting the belt speed to compensate for loaded and un loaded conditions. Soltec can give you
Electronics Forum | Tue Oct 06 14:29:14 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is to
Electronics Forum | Mon Feb 13 10:13:50 EST 2006 | slthomas
I have been through this before. At a med. device company they required every device that performed a measurement to be calibrated. O-scopes, calipers, 6-inch steel rules, etc. And thermocouples. While I can't see what difference it makes to the pr
Electronics Forum | Wed Mar 06 21:17:35 EST 2002 | davef
One, has anyone else ever experienced and dealt with a company debate regarding whether or not your reflow ovens should or should not be calibrated? Sure, it�s an excellent debating topic. We argue about stuff like this all the time. See, somebody
