Electronics Forum | Tue Oct 15 09:04:06 EDT 2002 | sueph
Dear Pete, thanks for the reply. My calibration procedure says pretty much what you said: variance of 10 degrees F. I am having a temp. swing of close to 80 degrees F. and no matter how I try to situate the thermocouple back into the preheater, I ca
Electronics Forum | Wed Oct 12 13:29:33 EDT 2016 | bobpan
Hello Todd, Go to my website: www.precision-repairs.com Send me an email from there and I will send you a document that has the calibration procedure in it. Bob
Electronics Forum | Fri Oct 02 17:06:02 EDT 2020 | dilogic
Is there somebody experienced in GSM Flexjet calibration procedures? I have some issues that I can't resolve and help is very appreciated... - Deni
Electronics Forum | Fri Mar 26 21:48:56 EDT 2010 | dman97
Can someone explain to me what I'm supposed to do after I have done the vision offset calibration procedure? The manual tells me to put solder paste down on all 25 holes of the stencil. After this the board drops down and the machine scans each fidu
Electronics Forum | Fri Jan 27 09:00:14 EST 2012 | davef
A thermocouple is a set of two wires welded together at one end, where a junction is formed between the two wires. Because each wire is composed of a different type of metal, each wire reacts differently to the temperature of the junction. Because of
Electronics Forum | Wed Jan 06 02:37:46 EST 2021 | ttheis
Don't know if this is relevant but I just came across this bulletin in the UIC docs: Document # TECH-0155 Software level:All Machine block:All Machine type(s):GSM1 Platform,GSM2 Platform,GSMx Platform,GSMxs Platform Target Users:Level 2 Topic:Part
Electronics Forum | Fri Mar 26 23:07:07 EDT 2010 | dekhead
Just a guess: Are you printing your fiducials on the fiducial side of the board? Fidicial Side is for Vision Calibration, Bare Copper Side is for Offset Calibration (Step 5 of procedure says "copper side uppermost"). After printing 25 fiducials o
Electronics Forum | Mon Jan 16 09:21:45 EST 2006 | russ
Probably from BTU?
Electronics Forum | Sun Jan 15 10:36:23 EST 2006 | Robert
Oven runs, input/output sensors work but no product tracking. Various resets have no effect and cannot reset Drive Cycle Timer due to "not calibrated" error. Where can I find the procedure without manuals on-hand?
Electronics Forum | Mon Apr 25 12:11:29 EDT 2005 | lyrtech
Hi, Does anyone know the rules to calibrate a feeder without any expensive jig test? We want to do that by our operators. Does anyone know the procedure? Thanks
