Electronics Forum | Wed Jan 14 05:54:48 EST 2004 | P.laxmanan
HOW FEEDERS CAN BE CALIBRATED? WHAT IS THE NORMAL RECOMMENDED CALIBRATION SCHEDULE (IN NORMAL USAGE)? WE DOING THE NORMAL MAINTANANCE OF CLEANING AND LUBRICATION.WHETHER THIS IS SUFFICIENT?
Electronics Forum | Mon Jan 12 15:03:43 EST 2004 | davef
We read what you wrote, but were unclear on what you were asking. Like: What's a feeder maintenance footprint? We don't consider feeders to be tools. Each is a calibratable machine with seperate maintenance and calibration schedules.
Electronics Forum | Wed May 07 20:55:35 EDT 2003 | davef
Bollocks!!!! We are unfamiliar with the term overturn, but it can not be that uncommon. Our intial inclination is to barrel into this SMT Engineer's nap-zone and blast him, but it might not be a politic approach. So, maybe we'll temper the tack we
Electronics Forum | Wed Jan 14 08:06:40 EST 2004 | davef
Feeders are "calibrated" according to the manufacturer's instructions. Check your manual. Maintenance schedules are based on: * Design * Use
Electronics Forum | Fri Jan 13 10:39:53 EST 2006 | samir
Good one! I remember at my old company, the auditors, both internal and external would go immediately to the refrigerator where we kept our glue and solder paste and then they would spend most of their time there, because they were afraid of all of
Electronics Forum | Fri Dec 11 19:59:40 EST 2015 | dontfeedphils
What exactly are you looking to verify? Following the manufactures recommended schedule for calibration should be enough. Another option is many AOIs have an option to run a bare board, when doing this it will invert what it's looking for, so every
Electronics Forum | Fri Nov 02 17:16:53 EST 2001 | davef
Planned maintenance is: * Scheduled based on the equipment supplier recommendations. These maintenance schedules may be modified based on clear-headed thinking that is documented. * Calibration may not be slipped, but the schedule may be moved up. [
Electronics Forum | Mon Apr 15 20:03:59 EDT 2002 | Jones
They work great as long as your conveyor speed has been calibrated and checked on some type of PM schedule. On some oven types these sensors can warn you to possible problems with the conveyor speed. Say the oven is calculating that the board is movi
Electronics Forum | Tue Feb 17 11:27:46 EST 1998 | KME
| Do anyone know of any feeder maintenance programs, | software, etc.? We carry over 1000 Fuji feeders and | would like know what the standard is to maintain these. | Any suggestions would be helpful. | Thanks, | Reggie Aquino Reggie: Give Fuji Ame
Electronics Forum | Tue Jun 14 18:12:59 EDT 2022 | emeto
Typically when you install equipment, you generate some maintenance schedule based on manufacturer's recommendation. For certain equipment we do Ppk analysis on intervals to prove it works in spec. If equipment is in spec and working as expected, the
