Electronics Forum | Thu Sep 09 07:46:04 EDT 2004 | cyber_wolf
Does anyone know of a better way to inject grease into the cam follower bearings on top of the turret on a CP43? Fuji wants you to use a plastic hypodermic syringe.(It works, but it is kinda a pain in the a$$)
Electronics Forum | Sat Sep 11 02:20:19 EDT 2004 | KEN
How about having a pre-greased set of 12 and simply swap them out?
Electronics Forum | Sat Dec 04 12:47:36 EST 1999 | Robert Halliday
Run a DTI over the X and Y edges of the table to ensure that your XY table is flat, adjust the four small screws to suit. Also check that the Z cams are not worn and that the Z cam followers are not siezed or worn(they are prone to flat spots when wo
Electronics Forum | Wed Jun 13 17:05:51 EDT 2001 | genny
Quick internet search revealed the following: http://www.cad2cam.com/HP_EGS/ also the following which looks like it copied some of the same info into its page: http://www.artwork.com/eesof/mds2dxf/mds2dxf.htm
Electronics Forum | Thu Jun 20 05:09:41 EDT 2002 | mattiasw
I am running a VisionPoint AOI equip. from DiagnoSYS, and I have a question regarding the calibration of brightness on the cameras. When I run system Calibration to check the camra brightness I should have the following values: Cam#1=126 Cam#2=126
Electronics Forum | Tue Jan 22 20:30:44 EST 2002 | davef
Start with the following: * Aegis ISC (Circuit CAM) * Mitron (GenRad) (CIMBridge) * CAE Technologies (C-Link)
Electronics Forum | Tue Nov 25 05:40:52 EST 2008 | wanderson
Calibration menu and then Index Cam Setup and follow the on screen instructions. (You can skip the focus step if you have not adjusted the camera's) The point you need to pay particular attention to is when it displays the intensity histogram, this
Electronics Forum | Tue Jul 14 08:09:42 EDT 2009 | fujiphil
Check the following: 1. Cam Motor cooling fan. Check if the fan is running or not. Clean the cooling fan cover. 2. Check the oil coolant control box. Check all the contactors does not trip. 3. Check the circuit protector M1CP8, M1CP9 and M1CP10. One
Electronics Forum | Sun Sep 11 07:16:31 EDT 2011 | smellew
We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzle position error." I > was wondering what is wrong and how do I fix > these errors? > > Thanks > We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzl
Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
