Electronics Forum | Fri Oct 06 09:03:07 EDT 2006 | RLM
Is anyone familiar with the automatic needle calibrator #820-10 for a Camalot 1818. It looks like a simple device but when I follow the instructions to create the calibration program all I get is the needle crashing down onto the calibration button.
Electronics Forum | Thu Dec 28 09:49:18 EST 2006 | slthomas
Tough call without seeing the board, but here's my best guess. You don't say if the glue dot is greater in height or diameter in the locations where you have printing (silkscreen), but I would guess that you might get either, or both, depending on ne
Electronics Forum | Tue Jan 02 09:54:56 EST 2007 | slthomas
Chalk this one up to semantics. Regardless of when you start pumping (do you use a needle with a foot? In that case the pump will run when the foot touches the board), your volume of epoxy is the same. You just have less room for it where there is si
Electronics Forum | Tue Dec 19 20:54:52 EST 2006 | Guest
Your experience is quite different than mine. At continues dispensing,I noticed that glue dispense volume increase as the material in the syringe decrease. My machine is using air time pressure pump. This is normal for this kind of pump since ai
Electronics Forum | Thu Jan 10 06:41:43 EST 2002 | Dreamsniper
Okay, I've read about the pros and cons about solder paste dispensing. Now, I have a Camalot 3800 and I want to experiment about dispensing solder paste. I have a needle gauge of 25GA, 23 and 22. My pcb components are; RC 0603-1812, Size B, C and D
Electronics Forum | Fri Jul 09 17:50:20 EDT 1999 | Jim Blankenhorn
Hi Carol- What you are asking for can be done. Variables you must account for include the paste viscosity, dispensing head speed, dispenser height relative to board surface, and needle size. You can use most any semi-automated system such as Camalo
Electronics Forum | Thu Jan 20 02:35:23 EST 2005 | Hannu
Hi guys Does anybody know of any second source for Camalot XyFlexPro needles, apart from Speedline? We have had problems with footed needles with the foot coming off as the glue that is supposed to hold it in place gets broken. Also it would be inte
Electronics Forum | Fri Jan 21 00:58:21 EST 2005 | Shito
Hi Hannu we are using the same machine and try different needles and the best one we come out and we still using it strong are the needles from EDF , check them out at http://www.efd-inc.com/ , you can ask for some samples . Shito
Electronics Forum | Fri Jul 09 19:35:05 EDT 1999 | Earl Moon
| Hi Carol- | What you are asking for can be done. Variables you must account for include the paste viscosity, dispensing head speed, dispenser height relative to board surface, and needle size. You can use most any semi-automated system such as Ca
Electronics Forum | Wed Aug 11 11:54:50 EDT 1999 | Dave F
| | Has anyone ever heard of this? I have a Camalot System 5000 and we were in a pinch to produce some prototype boards. We needed Sn62Pb36Ag2-no clean in a dispensing mesh. All I could get my hands on was some Interflux paste in a jar. The formulati
.png)
