Electronics Forum | Tue May 30 08:14:34 EDT 2000 | Aerin Bryson
I had a problem accessing my mail for along time, however, that is resolved now. Now I am having trouble sending email - I sent a test message to an internal smtnet recipient and one to an external recipient and both went OK. Other than that I have
Electronics Forum | Tue May 30 09:53:43 EDT 2000 | Neil Peaslee
Right now we are using a custom built web email solution to provide SMTnet web email. Unfortunately the service agreement recently expired and I have to keep a fairly close eye on it to make sure that it is running. Within the next few weeks we will
Electronics Forum | Tue Nov 20 09:22:15 EST 2018 | dekhead
Maybe info you need?
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 09:43:31 EST 2018 | dekhead
Sorry, you said LT... correct dwg. On LT (assuming not very early software version), you can discount that sensor by selecting "Center Justified" for screen image...
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
Electronics Forum | Tue Nov 20 21:13:32 EST 2018 | sabeti
Hi there, I have found another sensor and replaced it but the display still shows as "Insert Screen and Retry". Do you know what the issue would be? Thanks
winsouce.jpg)
