Electronics Forum | Mon Oct 13 09:22:14 EDT 2014 | rgduval
Deni, Thanks. I managed to do pretty much exactly that. I was able to get the changers to pop up, and check the vacuum on the nozzles. The first two nozzles are very well sealed into the changer (can't move them), but, the balance of the nozzles
Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Fri Apr 27 13:04:35 EDT 2007 | rmitchell
Hi, I am having some problems with my Fuji CP6 placement repeatability. The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on smal
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Thu Oct 11 15:18:32 EDT 2018 | dnachristen
I would suggest spending the extra money and getting the Mirtec. Simple to program, great support and reliable. We run 2 of these machines (MV3-L) 10 hours a day 6 days a week. Remember, you get what you pay for. If programmed correctly, the Mirte
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Thu Aug 26 13:20:56 EDT 2004 | pjc
Machine design plays a major factor in actual placement rate vs. the published tact time max speed. For example, random access horizontal turret head machines can vary greatly depending on nr. of different components and size ranges, while the dual g
Electronics Forum | Tue Aug 07 20:51:43 EDT 2001 | davef
Sowaza BIC? Ru the ball point pen people? Know no sites, like thet, but let�s see what we can do here. Wedabomb. First, rather than defining the controls your suppliers must use to produce your product, why not specify a DPMO rate er suppin like t