Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Fri Apr 27 13:04:35 EDT 2007 | rmitchell
Hi, I am having some problems with my Fuji CP6 placement repeatability. The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on smal
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Thu Oct 11 15:18:32 EDT 2018 | dnachristen
I would suggest spending the extra money and getting the Mirtec. Simple to program, great support and reliable. We run 2 of these machines (MV3-L) 10 hours a day 6 days a week. Remember, you get what you pay for. If programmed correctly, the Mirte
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Thu Aug 26 13:20:56 EDT 2004 | pjc
Machine design plays a major factor in actual placement rate vs. the published tact time max speed. For example, random access horizontal turret head machines can vary greatly depending on nr. of different components and size ranges, while the dual g
Electronics Forum | Tue Aug 07 20:51:43 EDT 2001 | davef
Sowaza BIC? Ru the ball point pen people? Know no sites, like thet, but let�s see what we can do here. Wedabomb. First, rather than defining the controls your suppliers must use to produce your product, why not specify a DPMO rate er suppin like t
Electronics Forum | Mon Aug 28 18:57:41 EDT 2000 | Earl Moon
Steve, This is a good, well repeated, not identified by IPC yet issue. I, and some others in industry, for years have proven and recommended smaller pads for various devices. I, and some others in industry, use 0402 pads for 0603 device types. IPC o
Electronics Forum | Mon Jul 05 03:53:36 EDT 2004 | johnwnz
Hey, this is something that I've looked at and published a paper on back in 2003 at Apex, actually pert of one, the other part was lookign at how effective X-ray systems (lamanography systems) were at detecting & measuring BGA void size accuratly (co
