Electronics Forum | Mon Aug 28 18:57:41 EDT 2000 | Earl Moon
Steve, This is a good, well repeated, not identified by IPC yet issue. I, and some others in industry, for years have proven and recommended smaller pads for various devices. I, and some others in industry, use 0402 pads for 0603 device types. IPC o
Electronics Forum | Mon Jul 05 03:53:36 EDT 2004 | johnwnz
Hey, this is something that I've looked at and published a paper on back in 2003 at Apex, actually pert of one, the other part was lookign at how effective X-ray systems (lamanography systems) were at detecting & measuring BGA void size accuratly (co
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Wed Jun 03 14:37:53 EDT 1998 | Anthony
I really appreciate everybody taking the time to help me out with this problem. I'm going to run your input by the design engineer, after that I may be taking you up on that offer to contact you Earl. Again; thank you! Anthony | If your board is si
Electronics Forum | Wed Jun 03 11:17:17 EDT 1998 | Brian Stumm
If your board is single sided you should convey it on a mesh belt conveyor. Unfortunately most assemblies these days are double sided which makes it difficult to convey on the mesh belt. Plus with the increasing population on SM boards the weight is
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i